Seating Q28 User manual

the BIFMA sustainability standard
①Tension Adjustment:
Turn the knob (under mechanism, not shown in photo) counter clockwise to
increase the tension for more resistance, turn knob clockwise to decrease
the tension for less resistance.
②Infinite Forward Tilt:
Turn lever clockwise to lower the front edge of the seat.
To raise the front edge of seat, tilt seat back with lever #3 until seat locks,
then rotate lever counter clockwise.
③Seat Tilt:
This paddle adjusts seat and backrest angle as a unit and allows chair
to free float. Lift paddle to allow chair to free float.
Push paddle down to lock the chair in any desired position.
④Pneumatic Lift Adjustment:
Lift tab up to adjust seat height
⑤Back Rest Angle Adjustment:
Pull up on the tab to make adjustments to back rest angle or
to allow the back rest to move with your body. Push paddle down to lock.
⑥Adjustable Seat Depth:
Lift lever up to allow for adjustment of seat forward &
back. Release lever to lock seat in desired position.
Seating Inc. | 60 N. State Street | PO Box 898 | Nunda, NY 14517 | 800.468.2475 | [email protected]
Q28 ASD
Mechanism Instructions
01.19
2
6
3
4
5
1

C1
C1
the BIFMA sustainability standard
①Place Base and Caster Assembly
(Figure A) on carpeted floor.
②Insert Pneumatic Cylinder (Figure B)
Into Base (Figure A) by inserting
tapered end (B1).
③Place the seat assembly on the
Pneumatic Cylinder (Figure B) by
inserting the Pneumatic Cylinder
Activator (B2) into the opening (C1)
of the mechanism (*Figure C).
*Actual Q28 mechanism not shown, opening is similar.
④Apply pressure for a secure fit.
Seating Inc. | 60 N. State Street | PO Box 898 | Nunda, NY 14517 | 800.468.2475 | [email protected]
Q28
Assembly Instructions
01.17
Figure A
A1
Figure B
B2
B1
*Figure C
Step 1
⑤At the completion of step 1, the bottom
of the chair assembly should look like
figure D.
⑥Lay Seat Assembly on a carpeted floor
as shown in Figure F.
⑦Take Backrest (Figure E) and slide
Backrest Bar (E1) into slot (F1) until the
three holes line up for Allen head
screws.
⑧Hand tighten all three Allen head
screws (Figure G) before tightening
with Allen head key provided.
Ratchet Back - Lift back all the way up
to release ratchet mechanism. Push
back all the way down to activate. Lift
back up slowly for 7 locking positions.
Not available on Grid or Jay Series.
Step 2
Figure D Figure F Figure G
F1
Figure E
E1