Security Cameras Direct CDC3008ST2 User manual

Please read this manual before using your camera, and always follow the
instructions for safety and proper use. Save this manual for future reference.
CDC3008ST2_CM
Compact Color
Dome Camera
Product: CDC3008ST2

ii www.scdlink.com
LEGAL NOTICE
Security Cameras Direct’s products are designed to meet safety and
performance standards with the use of specic Security Cameras Direct
authorized accessories. Security Cameras Direct disclaims liability
associated with the use of non-Security Cameras Direct authorized
accessories.
The recording, transmission, or broadcast of any person’s voice without
their consent or a court order is strictly prohibited by law.
Security Cameras Direct makes no representations concerning
the legality of certain product applications such as the making,
transmission, or recording of video and/or audio signals of others
without their knowledge and/or consent. We encourage you to
check and comply with all applicable local, state, and federal laws
and regulations before engaging in any form of surveillance or any
transmission of radio frequencies.
Other trademarks and trade names may be used in this document
to refer to either the entities claiming the marks and names or their
products. Security Cameras Direct disclaims any proprietary interest in
trademarks and trade names other than its own.
No part of this document may be reproduced or distributed in any form or by
any means without the express written permission of Security Cameras Direct
© 2010 Security Cameras Direct. All rights reserved.
Security Cameras Direct
1 Security Cameras Direct Way, Luling, TX 78648
Sales/Support: 1.800.316.6027 | Fax: [phone]

iii
Compact Color Dome Camera
WARNINGS & CAUTIONS
WARNING
!Do not use the camera if fumes, smoke or a strange
odor is emitted from the unit, or if it seems to not
function correctly. Disconnect the power source
immediately and consult your supplier.
WARNING
!
Do not adjust or modify the camera’s internal circuits or
power supply modules. No user serviceable parts exist
inside. For internal settings and repairs, consult your
supplier.
CAUTION

Always follow the instructions in the installation guide
when applying power. Fire and equipment damage can
occur if power is applied incorrectly.
CAUTION
To prevent damage do not drop the camera or subject it
to strong shock or vibration.
CAUTION
Never point the camera toward the sun. Use caution
when operating the camera in the vicinity of spot lights
or other bright lights and light reecting objects.

iv www.scdlink.com
WARNINGS & CAUTIONS
CAUTION

Do not install the camera or route video cables
near a TV, radio transmitter, magnet, electric motor,
transformer, or audio speaker. Magnetic elds
generated by these devices may distort the video image.
CAUTION
Use the camera only in areas where the temperature
and humidity are within the recommended
specications.

1
Compact Color Dome Camera
TABLE OF CONTENTS
Table of Contents
SECTION 1 Features ...............................2
1.1 Camera components . . . . . . . . . . . . . . . . . . 2
SECTION 2 Installation .............................4
2.1 What’s in the box . . . . . . . . . . . . . . . . . . . . . 4
2.2 What you need .......................4
2.3 Installing the camera . . . . . . . . . . . . . . . . . . 4
2.4 Aiming the Camera . . . . . . . . . . . . . . . . . . . . 7
SECTION 3 Cleaning ...............................9
SECTION 4 Specifications ..........................10
SECTION 5 Troubleshooting ........................11

2www.scdlink.com
SECTION 1: FEATURES
SECTION 1 Features
The CDC3008ST2 camera is a very low-prole indoor camera for
locations where unobtrusive surveillance is important. This cameras
includes:
• 420 Lines of resolution
• 78° eld of view
• Automatic white balance and automatic gain control
• Low power consumption – 12 V DC @ 120 mA
1.1 Camera components
Base
Lens
Up – Down Adjust
Set Screw (1 of 2)
Drop Cable
Video
Connector Power Connector
CDC3008ST2 with dome removed

3
Compact Color Dome Camera
SECTION 1: FEATURES
Connect
Connect
Single camera system with monitor
Multiple camera system with DVR and monitor

4www.scdlink.com
SECTION 2: INSTALLATION
SECTION 2 Installation
2.1 What’s in the box
The camera package contains:
• Camera assembly
• Instruction manual
2.2 What you need
To install the camera, you will need:
• Hardware and tools to attach the camera to the mounting surface
• #0 or #1 Phillips screwdriver
• Video and power extension cable
• 12 V DC power source (SCD model PWR12800R recommended)
2.3 Installing the camera
1. Remove the camera dome by rotating it (relative to the base)
approximately ¼ turn counter-clockwise (90°) until it stops, and
then carefully lift it off the base.

5
Compact Color Dome Camera
SECTION 2: INSTALLATION
2. Position the camera base on the mounting surface so that the
camera lens points at the surveillance target. Using the base as
a template, mark the location of the mounting screw holes. Also
mark the hole location for the camera drop cable.
Hole for
drop
cable
Mounting
screw
hole
approx. 2.25”
3. Drill holes into the mounting surface for the mounting screws, wall
inserts, or other attachment hardware as required.
4. Drill a ¾” hole for the camera drop cable. This hole should be
contained within the camera base when the camera is mounted.
5. Route the camera drop cable through the drop cable hole and align
the camera base with the mounting screw holes.

6www.scdlink.com
SECTION 2: INSTALLATION
6. Attach the camera base to the mounting surface with the
attachment hardware.
7. Connect the camera drop cable connectors to the video and power
extension cable. Route the extension cable to the monitor or DVR
and the power source.
Video
connector
to monitor
or DVR
Power
connector
to 12 V DC
power source
Cable to monitor
or DVR, and
power source
Connect
Cable attachment
NOTE Connectors on the power extension cable are different at each
end!

7
Compact Color Dome Camera
SECTION 2: INSTALLATION
8. Apply power to the camera.
9. Verify that video from the camera can be seen on a monitor or
DVR.
2.4 Aiming the Camera
1. Use a Phillips screwdriver to loosen the up-down adjustment set
screws. One is on each side of the camera module bracket.
Up - down
adjustment
set screw
2. While observing video from the camera, rotate the camera module
bracket to center the surveillance target in the camera video
image.

8www.scdlink.com
SECTION 2: INSTALLATION
3. Tighten the up-down adjustment set screws to secure the camera
module bracket in place.
4. Replace camera dome by inserting the locking tabs into the slots
in the base, and rotating it approximately ¼ turn clockwise. Ensure
that the window in the dome is over the camera lens.

9
Compact Color Dome Camera
SECTION 3: CLEANING
SECTION 3 Cleaning
Clean the camera dome and lens with an approved glass cleaning
solution and a lint free cloth.
• Remove all foreign particles, such as plastic or rubber materials,
attached to the camera housing. These may cause damage to the
surface over time.
• Dust can be removed from the unit by wiping it with a soft damp
cloth. To remove stains, gently rub the surface with a soft cloth
moistened with a mild detergent solution, then rinse and dry it with
a soft cloth.
CAUTION

Do not use benzene, thinner or other chemical products
on the camera assembly; these may dissolve the paint
and promote damage of the surfaces. Before using any
chemical product, read the instructions carefully.

10 www.scdlink.com
SECTION 4: SPECIFICATIONS
SECTION 4 Specications
Model CDC3008ST2
Image Sensor ¼” Sharp CCD
Resolution 420 TV Lines
Lux Rating 1 LUX
Pixels 510 (H) x 492 (V) NTSC
Video output 1 Vp-p @ 75Ω, composite video
Scanning system 2:1 Interlace
Synchronous system Internal, negative sync
Gama correction 0.45
Automatic Electronic Shutter
(AES) 1/60 ~ 1/100,000 sec.
Automatic Gain Control (AGC) Automatic
White Balance Automatic
Lens 3.6 mm/F2.0
S/N ratio ≥ 48 dB (AGC off)
Operating temp 14˚F ~ 113˚F, RH 95% max.
Power 12 V DC @ 120 mA
Size 3.46” (dia.) x 2.65” (H)
Weight 8.81 oz.

11
Compact Color Dome Camera
SECTION 5: TROUBLESHOOTING
SECTION 5 Troubleshooting
Before sending the camera for repair, rst, make sure that the camera
is installed correctly, and then follow the suggestions listed below. If it
still does not perform adequately, please consult your supplier or contact
Security Cameras Direct at 800.316.6027.
1. No picture on the monitor screen:
a. Check that all connected devices are powered on.
b. Conrm that the voltage is correct.
c. Conrm that the power supply provides enough current to
power the camera.
d. Check that all video cables are correctly connected.
2. Video has owing interference ripples:
a. Check the power supply for excessive AC noise, or replace
the power supply.
b. Ensure that all video connections are tight. Check the video
cable for damaged connectors and breaks in the shielding
layer.

12 www.scdlink.com
c. Check the monitor display for ripple on other video channels.
d. Check cable routing for proximity to high electrical or
magnetic elds.
3. The picture is not clear:
a. Check the camera zoom and focus adjustments.
b. Check that your monitor is correctly adjusted.
c. Conrm that the glass in front of the lens is clean.
If there is dust, dirt or ngerprints on the glass, the image
quality will be affected. To clean the glass use a soft, dry and
non-abrasive cloth or a commercially available lens cleaning
set.
4. The picture has interference:
a. The camera or cables to the camera may be close to a high
voltage source, such as a power generator.
b. The BNC cable is not terminated properly.
c. The video cables are not connected properly.
SECTION 5: TROUBLESHOOTING

13
Compact Color Dome Camera
SECTION 5: TROUBLESHOOTING
5. The camera doesn’t operate:
a. Your cable run may be too long and you are experiencing a
drop in voltage.
CAUTION

This camera is a precision instrument and when
treated with care, will provide years of satisfactory
performance. If a problem does occur, do not open the
camera to make repairs. Servicing should always be
referred to your supplier.

14 www.scdlink.com