Seedburo ST-SS P Manual

ST-SS Model P Sieve Shaker
Setup and User Responsibilities
2293 S. Mount Prospect Rd.
Des Plaines, IL 60018
Toll-Free Phone:
1-800-284-5779
Website: www.seedburo.com
E-Mail: [e-mail]

• Keep all original packaging. In the event your Sieve Shaker requires shipping
for warranty maintenance or other reasons, damage to any Sieve Shaker not
shipped in original packaging will be the responsibility of the shipper. Any
Sieve Shaker returned in a carton not suitable for return delivery back to
owner will be charged for new original packaging.
• e leveling feet on your Sieve Shaker are adjustable. using a 9/16" wrench,
loosen the anged locking nut on the leg and rotate leg to desired height.
Retighten the anged locking nut to chassis to set leveling foot height. Make
sure anged locking nuts are tight to chassis, as they add stability to the Sieve
Shaker during use.
• Sieve Shaker slide rails are lubricated in the factory, and should be lubricated
with light general purpose oil before rst use. Keep slide rails cleaned and
lubricated with light general purpose oil to reduce wear on the motor and
other components of the Sieve Shaker.
• To install included pan holder bracket to platen: align holes in platen and
pan holder bracket with pan holder bracket under platen. Insert included
machine screws through the top of the platen, so the screw heads are up.
Fasten tightly with included keps nuts from below.
• Regularly use compressed air to remove debris and dust from under the
black safety cover.
• Your Sieve Shaker has been calibrated at the factory for accuracy. If you feel
your Sieve Shaker is not calibrated correctly or you have other questions or
concerns, please contact AgPoint Precision.
• For warranty and non-warranty repair questions, please contact your
Seedburo Equipment Company sales person.
Notes From The Manufacturer...
1 [phone]
agpointprecision.com
[email protected]

Counter Operation
is ST-SS Model P Sieve Shaker has a new counter module. In addition to normal counting
functions, the counter module has a set up menu to aid in the setup and maintenance of your new Sieve Shaker.
e counter module does not require batteries and all parameters are saved for the next operation.
Turn on the power switch. When prompted,
press the UP/DOWN buttons simultaneously
to enter the set up menu.
Once in the setup menu, the UP button
will cycle through the three setup options.
Pressing the DOWN button will enter the
selected function.
A jog function has been provided to allow
the movement of the Platen at low speed
for cleaning/oiling the slide shafts and
positioning the Platen for shipping. With
Jog selcted, press the DOWN button to
enter the function. The UP/DOWN buttons
will Jog the Platen at low speed. Press the
START Button to exit.
PRESS -- >
SETUP -- >
SELECT
ENTER
JOG

The contrast of the LCD character display
can be adjusted between sixteen levels.
With Contrast selected, press the DOWN
Button to enter the function. Use the UP/
DOWN buttons to adjust the contrast. Once
the desired Contrast level is set, press the
START Button to save the changes and exit.
To verify the correct operating speed of
your Sieve Shaker, press the DOWN Button
to enter the RPM Function. Press the START
Button to Start/Stop the motor. While the
motor is running, the motor shaft RPM
will be displayed. To exit the RPM function,
press the DOWN Button. Press the DOWN
Button again to exit the set up menu and
resume normal operation.
Using the UP/DOWN buttons, select the
desired number of counts. Press the START
button to save changes to the count and to
start the cycle.
CONTRAST
RPM
COUNT
30