
- 6 - 04/2023
2023, .
HEATING WATER TO AGIVEN TEMPERATURE AND MAINTAINING IT
• Pressing button will start heating the water to the preset value of
45°C. When it has been reached, the maintain temperature function
will start. After this time has elapsed, the kettle will turn itself off.
• If you wish to adjust the default temperature 45°C, then after pressing
button , use the (plus) and (minus) buttons. The temperature
can be adjusted in the range 35-95°C. Each time the or button
is pressed, the set temperature is decreased or increased by 1°C.
Note:
If you press button during the water heating or boiling
process, the activity will end and the kettle will switch to the
maintain set temperature mode.
The set temperature can be adjusted during the maintain
set temperature mode as required.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CLEANING AND MAINTENANCE
Warning:
Prior to any cleaning or maintenance, always
disconnect the base stand from the power socket and
allow the kettle to cool down.
Do not wash the kettle, its base stand or power cord
under running water and do not submerge them in
water or another liquid.
Do not use solvents, abrasive cleaning products,
etc. for cleaning the electric kettle or its base stand.
Otherwise, its surface may be damaged.
• To clean the external parts of the kettle, use adry cloth or acloth
dipped in aweak solution of neutral kitchen detergent. After washing it,
wipe the surface with alightly damp cloth and then wipe dry.
• Wipe the internal parts of the kettle using asoft sponge or clean
cloth dipped in clean warm water. Do not use detergents or any other
chemical agents on the internal parts. After cleaning the kettle, rinse it
out several times with clean water.
• To clean the base stand, use only adry cloth.
Removing limescale deposits
• During normal use, substances contained in water accumulate on the
appliance to form so-called limescale deposits. These may negatively
affect the lifetime of the kettle and ruin the taste and appearance of
your beverage, so it is important to regularly remove them based on
how frequently the kettle is used.
• When using the kettle at afrequency of 3 to 5 times per day, we
recommend to remove water scale deposits:
– once per month in areas with hard and very hard water;
– once every two to three months in areas with soft and medium hard
water.
• Limescale deposits can be cleaned away using standard
available limescale removal products (according to the
manufacturer'sinstructions) or use:
– 8% white vinegar, generally available in stores. Fill the kettle with
1 litre of water and¼ litre of vinegar. Bring the solution to aboil and
leave it to act in the kettle for 2hours. Then empty the kettle and
before further use, boil clean water in it four to five times.
– citric acid. Boil 1l of water in the kettle, into the boiled water, add 30g
of citric acid and allow the solution to act for about 30 minutes. Then
empty the kettle and before further use, boil clean water in it four to
five times.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
STORAGE
• When you have finished using the kettle and and have cleaned it,
place it and its base stand in aclean, dry place out of children'sreach.
Keep the stored kettle and its base stand away from extreme
temperatures, direct sunlight and excessive humidity and do not store
it in an overly dusty environment.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TECHNICAL SPECIFICATIONS
Rated voltage range ..................................................................................220-240 V
Rated frequency...........................................................................................50/60 Hz
Rated power input ............................................................................ 1,750-2,000 W
Volume ......................................................................................................................... 1.7 l
Changes to text and technical parameters are reserved.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF
USED PACKAGING MATERIALS
Dispose of used packaging material at asite designated for waste in your
municipality.
DISPOSAL OF USED ELECTRICALAND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that
used electric or electronic products must not be added to
ordinary municipal waste. For proper disposal, renewal and
recycling, hand these appliances over to determined
collection points. Alternatively, in some European Union
states or other European countries you may return your
products to the local retailer when buying an equivalent
new product. Correct disposal of this product helps save
valuable natural resources and prevents potential negative effects on the
environment and human health, which could result from improper waste
disposal. Ask your local authorities or collection facility for more details. In
accordance with national regulations penalties may be imposed for the
incorrect disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electrical or electronic equipment, ask your
retailer or supplier for the necessary information.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this
product, request the necessary information about the correct disposal
method from the local council or from your retailer.
This product meets all the basic requirements of EU
directives related to it.