EN-6 EN-7
To monitor a channel, hold down the DOWN▼ button. The monitoring
function will be activated after approximately three seconds.
Release the DOWN▼ button to stop channel monitoring.
During channel monitoring the receiver circuit in the Radio’s will
not listen to CTCSS codes.
The Radio’s is capable of voice activated (VOX) transmission. In VOX
mode, the radio will transmit a signal when it is activated by your voice
or other sound around you. VOX opration is not recommended if you
plan to use your radio in a noisy or windy environment.
VOX mode will be overrided when you press the “Call/PTT button.
Press the MENU button three times, the current VOX setting will
ash on the display and the VOX icon will display,
Press UP▲ button to set the VOX sensitivity level between 1 and
3 level (level 3 is the most sensitive level).
Press Down▼ button until “OF” appears on the display to turn VOX
OFF.
Press the Call/PTT button to conrm and return to stand-by mode.
Press the UP▲ button for 3 seconds: The “SCAN” function indicator
will appear on the display and the channel will scan continuously from
1 to 16 (according to current CTCSS subchannel setting only).
Press the Down▼ button to start scanning channels from 16 to 1.
Once an active channel is found, the scanning will stop and you can
listen to the transmission.
When the transmission is on the found channel stop, the scanning will
resume automatically.
If you press Call/PTT button while listening to a found channel, the
device will go back to stand-by mode on the found channel.
