Serene Furnishings NEPTUNE User manual

NEPTUNE 3'0 BED
1.Please read through and follow the step-by-step instructions in the leaflet.
3.Please do not discard any packaging before you have checked all the parts and fittings are included.
4.Assemble this product on a flat and clean surface to avoid scratching.
5. o not tighten any bolts before all the parts have been assembled loosely. Product and/or fittings might be damaged by over
tightening screws or bolts. Beware of cross -threading the screws or nuts during assembly.
6.Keep fittings away from childrens' reach.
SAFETY WARNING: Do not stand on the bedbase without a mattress on it.
COMPONENT PARTS
FITTINGS
[1] - M6x20mm bolts x 8pcs
[3] - M6 Insert Nuts x 2pcs
[A] -Headend
[B]
-Footend
2.We recommend that assembly is done in the room intended for use and it is assembled by two people.
[C]
- Siderail x 2pcs
[E] - Wooden Slat x 12pcs
[F] - Side Plastic Holder x 24pcs
STEP 1 : Attach the Siderails(C) to the Headend(A) and
Footend(B).
[D]
- Across Bar x 1pc
[2] -
M6x35mm bolts x 2pcs
[5] - M6 Allen Key x 1pc
STEP 3 :
Insert the Sprung Slat(E) into the Plastic Holders(F) as shown.
Gently tap the Plastic Holders into the holes drilled on the
Siderails.
STEP 2 :
Attach the Across Bar( ) to the
Siderails(C).
Rubber Mallet
(Not Provided)
[4] -
Washers x 8 pcs
A
B
2
3
C
D
C
F
E
A
C
1
4
NEPTUNE NEW VERSION 90cm BED

METAL 75cm to 90cm GUEST BED: ASSEMBLY INSTRUCTIONS