Shark DUO clean ZERO-M Lift-Away ZU700C User manual

ZU700C
Performance Lift-Away®
Upright Vacuum
QUICK
START
GUIDE
Use this Quick Start Guide
to learn about your new
vacuum’s great features.
Please be sure to read the enclosed Shark®Owner's Guide prior to using your unit.
To register your product, or for answers to frequently asked questions, visit registeryourshark.com.
ZU700C_QSG_E_PLT_Mv2
To open the brushroll garage, slide both release buttons on the floor nozzle away from you, towards the
back of the nozzle, then lift o the lid. Clear away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down on
both sides of lid until it clicks securely into place.
CLEANING THE BRUSHROLL
Zero-M™ Technology
Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum. If you run
over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M™ technology to remove it for you. If
some fibers remain wrapped around brushroll after continued use, carefully cut debris with scissors and remove from brushroll.
To remove the Soft Roller from the nozzle, lift it out by
the pull tab. Tap loose debris o the Soft Roller. Use a
dry towel to wipe the Soft Roller clean, or to remove
any debris caught in the teeth behind the Soft Roller.
Hand wash the Soft Roller as needed. Use only
water, and let air-dry completely for at least
24 hours. Reinsert the Soft Roller under the rubber
bumper in the front of the nozzle until it clicks into place.
CLEANING THE SOFT ROLLER
MAINTENANCE
©2019 SharkNinja Operating LLC. SHARK, DUOCLEAN, and LIFT-AWAY, are registered
trademarks of SharkNinja Operating LLC. Zero-M is a trademark of SharkNinja Operating LLC.

AVacuum Pod
BMotorized Floor Nozzle
CHandle & Hose
DWand
EPet Multi-Tool
FDuster Crevice Tool
Attach onboard
accessories
WHAT’S INSIDE:
For additional parts and accessories,
visit sharkaccessories.com
For complete maintenance instructions,
see the enclosed Owner's Guide.
1
(Click)
ASSE MBLY
A
C
D
B
1. Attach vacuum pod to floor nozzle.
2. Insert wand into pod.
3. Insert handle and hose into wand.
4. Press hose into back of pod.
(Click)
2
(Click)
3
(Click)
4
Add desired
cleaning accessory
2 WAYS TO CLEAN:
1
UPRIGHT
2
LIFT-AWAY
Carpet
Hard Floor
Carpet
Hard Floor
Lift-Away
Release
Carpet
Hard Floor
OR
Handle
Release
Wand
Release
Carpet
Hard Floor
Suction
Control
Power
Press the Power/Surface
Selector button to turn the
vacuum on or o.
Floor Setting
Slide the Power/Surface
Selector button up or
down to choose floor type.
EF
OR