Shark ROCKET IZ142 User manual

QUICK
START
GUIDE
Please make sure to read the enclosed Shark®Owner’s Guide prior to using your vacuum.
IZ142_QSG_MP_Mv7
EMPTYING THE DUST CUP
IZ142
Use this Quick Start Guide
to start using your new
vacuum’s great features.
For questions, visit us online
at sharkclean.com/support
Register your vacuum at
registeryourshark.com
CORDLESS MULTIFLEX®
ROCKET®
1. To empty the dust cup,
first disconnect the
handheld vacuum from
the wand by pressing
the Wand Release
button and pulling
up on the handheld
vacuum.
Wand Release
Button
CleanTouch
Dirt Ejector
VERSATILE CLEANING
Slide the power button
to the desired power
setting. Place your foot
on the floor nozzle
and tilt the handheld
vacuum back.
To detach the wand for
above-floor cleaning, stand
the vacuum upright, then
press the Nozzle Release
button on the bottom of the
wand and pull the wand up
to disconnect it.
To detach the handheld
vacuum, press the Wand
Release button and lift the
handheld vacuum o the
wand.
Attach a cleaning accessory,
then choose the power
setting.
NOTE: Brushroll will only engage
when the handle is tilted back.
OR
THEN
2. Position the dust
cup over a trash
bin and slide the
CleanTouch™ Dirt
Ejector forward.
©2019 SharkNinja Operating LLC. SHARK and ROCKET are registered trademarks of SharkNinja
Operating LLC. CLEANTOUCH and DIRT ENGAGE are trademarks of SharkNinja Operating LLC.

WHAT’S INSIDE: ASSEM B LY
For complete maintenance instructions, see the enclosed Owner's Guide.
For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
F G
AHandheld Vacuum
BDirt Engage™ Floor Nozzle
CWand
DPet Multi-Tool
E8" Crevice Tool
FCharger
GPost Motor Filter (Pre-Installed)
ED
POWER SETTINGS
LI-ION BATTERY
NOTE: The Li-Ion battery
comes partially charged.
Charge fully before first use.
Battery Indicator Lights
A
B
C
2
(Click)
1
(Click)
OFF BARE FLOOR
SETTING CARPET SETTING BOOST MODE
Slide switch to the
top to turn o power.
To begin vacuuming
in Standard Mode,
slide switch to the
appropriate setting.
Bare Floor/Area Rugs
The brushroll spins slowly
to clean bare floors and
low-pile arearugs.
The brushroll spins
faster to pick up debris
below the surface
ofyour carpets.
For an added boost in
power, pull the Trigger
on the handheld
vacuum. Release it
to return to standard
power.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the
trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
In Use
Full
Charge
Mid
Charge
Low
Charge
Nearly
Empty
No
Charge
Charging
Low
Charge
Mid
Charge
Nearly
Full
Full
Charge
NOTE: Full charge takes approximately 3 hours.
CHARGING
To charge, remove the handheld vacuum from the wand by
pressing the Wand Release button and pulling up. Plug the
charger into the charging port.
©2019 SharkNinja Operating LLC.
Battery Run Time
MODE MINUTES
Hand Vac 40
Bare Floor/
Standard Mode 25
Carpet Mode 22
Boost Mode
(Hand Vac) 10