Sharp AQUOS LE810 Guide

AQUOS
LE810/820
QUATTRON LED REPLACEMENT
LC-60LE810/820
Ver. FF

AQUOS
LE810/820
QUATTRON LED REPLACEMENT
LEDKIT60LE8X
(1) Side LED Strip
(2)Top or Bottom LED Strip
Kit Part number: LEDKIT60LE8xKit Part number: LEDKIT60LE8xLEDKIT60LE8xLEDKIT60LE8x
(1) Wiring Harness
LEDKIT60LE8x
1

Tools and Additional Requirements
•Very clean work space, no animals or pets. (Clean room preferred).
•ESD safe work station with grounding strap.
•Bright work lamp (for visibility and dust inspection).
•#2 Philips Screwdriver / Bit for clutched power screwdriver (Unit
disassembly).
•#1 Philips Screwdriver / Bit for clutched power screwdriver (Panel
disassembly).
•Needle Nose Pliers (disconnect and reconnect LED PWB’s / harnesses).
•#0-1 Standard Blade screwdriver (Assist with harnesses removal).
•Rubber Gloves. (powder less)
2

Time Study
Unit disassembly = 20 minutes.
Front glass panel and front cab removal = 10 minutes.
Panel disassembly / separation = 10 minutes.
Harness inspection = 5 minutes.
LED swap test 5 minutes each. Can be up to 20 minutes for all 4 LED
strips. (10 minute average)
Install new LED assembly = 5 minutes.
Re-assemble entire set = 40 minutes.
Total process time = 1hour 40 minutes
3

Unit Disassembly
Remove 1 machine
screws. (red)
Remove AC cord Cover.
Disconnect AC cord from
power unit.
4

Unit Disassembly
Remove 20 machine
screws (red). (Green)
denotes long screw.
Remove 5 plastic screws.
(yellow)
Lift off Back Cover.
Remove 3 machine
screws from support
cover. (orange)
Remove (4) stand screws
and lift set off stand.
(not illustrated)
Support Cover
5

Unit Disassembly
Remove 2 silver machine
screws from stand cover
(red).
Remove 2 plastic screws
from stand cover.
(yellow)
Lift off stand cover.
Stand Cover
6

Unit Disassembly
Disconnect and remove 2
FPC’s that connect
between the T-Con and
LCD panel.
See FPC detail on next
slide.
Gently pull and guide the
FPC through the ferrite
holder. The FPC’s should
be free and ready for
panel separation.
Remove FPC X2
7

FPC Detail
FPC Removal
Swing lock up
Lift FPC up and off connector.
FPC Installation
Insert FPC into connector and
verify that the FPC is
“hooked” into the connector
before locking.
Next, swing lock down.
8

Removing Front Glass Panel
Remove the 4 LCD fixing
angles.
Remove 25 screws and
remove front glass panel
assembly.
The LE810 uses the same
procedure without the
front glass panel.
LCD Fixing Angle
LCD Fixing Angle
9