Page 3
THE INFORMATION CONTAINED IN THIS MANUAL IS
FOR INFORMATIONAL PURPOSES ONLY AND LIFT-
TECH INTERNATIONAL, INC. DOES NOT WARRANT
OR OTHERWISE GUARANTEE (IMPLIEDLY OR EX-
PRESSLY) ANYTHING OTHER THAN THE COM-
PONENTSTHAT LIFT-TECH MANUFACTURES AND AS-
SUMES NO LEGAL RESPONSIBILITY (INCLUDING,
BUT NOT LIMITED TO CONSEQUENTIAL DAMAGES)
FOR INFORMATION CONTAINED IN THIS MANUAL.
TO BUILD MOTOR DRIVEN TRAVERSE
ARRANGEMENT
GENERAL
The following items are required for assembly of the tra-
verse arrangement: One Series 700 deck mounted wire
rope electric hoist, one driver truck, one trailer truck and
one gearmotor. The builder will have to furnish the mate-
rial required for mounting the electrical enclosure and, if
required, material for mounting a resistor. The resistor is
required for three speed hoists only.
The builder must also furnish a means of supplying power
to the traverse.This will be collectors, festooned cable or
cable reel.
MOUNTING HOIST
Although some traverse trucks have more than one set
of mounting holes for the hoist, the specified hoist will
match only one set of holes.
Place trucks, with mounting pads up, on supports that
allow the wheels to hang free.Orient the trucks as shown
in Figure A.With the gear case note (stenciled on trucks)
at the same end of both trucks, the driver truck is on the
right as the traverse is viewed from the gear case side
(this is the reverse of Figure A).
Lower the hoist, with the gear case side properly oriented
to the notes on the trucks, onto the trucks, adjusting the
distance between the trucks to match the hoist mounting
Figure B.
holes.Bolt hoist down with hardware furnished with trucks.
See Figure B.
MOUNTING CONTROL PANEL
Refer to Figure C. If hoist is single or two speed, builder
need supply only item A and four bolts, lockwashers and
nuts (item E, F and G) for securing control panel.
For a three speed hoist, all the material listed in Figure C
is required. The additional material is required for the
secondary resistor.
Using first quality steel, free of rust and mill scale, fabri-
cate the required material and assemble on the trailer
truck as shown on Figure C. It is strongly recommended
that any welding be done by qualified welders.
The control module for traverse control is mounted in the
control panel.
BALLAST RESISTOR MOUNTING – OPTIONAL
The ballast resistor for the traverse is an optional item. If
ordered, all material listed in Figure D is required for
mounting and must be furnished by the builder.
Using first quality steel, free of rust and mill scale, fabri-
cate the required material, assemble the resistor drip tray
and then assemble the material on the traverse gear case
unit as shown in Figure D.
ELECTRICAL
The traverse wiring diagrams are shown in 113533-78.
