PAGE 2
1.
FRAME ASSEMBLY
Assembly is easiest if you layout all parts as
shown.There are eight - 54.5" x 2" Rafter
Poles , they are swedged on both ends, and
have 3 pre-drilled holes. The nine- 77" x
1.5" Cross Poles do not have swedged
ends. You can set aside the eight- 76" x 2"
Leg Poles , they are swedged on one end
and have pre-drilled holes at the base & the
top. It is very important that you determine
which of the 3 & 4 way connectors are
meant for the sides and which are for the
crest. The side connectors have a sharper
bend.
2. CONNECT
PIPES
Start with the center, then
assemble each side.
4. ATTACHINGLEGS Insert both middle legs on
one side of the frame,swedged
end up, then the end legs on that
same side. Repeat for the other side. Now you can secure the legs
to the side bend connectors and secure the cover with bungee cords.
Side Bend Connectors
(sharp bend)
Top Crest Connectors
(shallow bend)
3. PLACE COVER
Place cover over frame so that the
grommetted portion is face down,
this allows the valance to wrap
around and cover the frame eaves.
6. SECURING COVER
Working inside, under-neath the unit, begin with the corners.
Insert the cord
of the bungee-ball through the grommett and around the 77" Cross Pole, then
around the ball. By doing this from the inside it will hide the bungee-ball and give
a cleaner look. When all 4 corners are secured, work from side to side to get an
even fit.
5. SECURING LEGS
8 Short Pins are used to secure legs to
side bend connectors.
6.1