Silonn SLIM17B User manual

INSTRUCTION
MANUAL
Ice Maker
Rev01(A)
SLIM17B/SLIM17T/
SLIM17G1/SLIM17G
[e-mail]

IMPORTANT SAFETY INFORMATION ............................ 01
PRODUCT INTRODUCTION ......................................... 03
CONTROL PANEL INTRODUCTION ........................................ 04
USING YOUR ICE MAKER ..................................................... 05
CLEANING AND MAINTENANCE ....................................... 07
PRODUCT SPECIFICATIONS ......................................... 08
TROUBLESHOOTING .................................................. 09
SHORT AND LONGTERM WARRANTY INFORMATION ........ 10
PAGE CONTENT

01
IMPORTANT SAFETY INFORMATION
• Voltage power from outlet must match specifications on
appliance nameplate.
• This appliance must be grounded.
• Using an extension cord may cause overheating and increase
the risk of fire.
If an extension cord MUST be used:
1) Only use an extension cord with grounding plug.
2) The marked rating of an extension cord must be equal to or
greater than the rating of this appliance.
• Do not operate if any component, including the cord or plug, is
damaged.
• Unplug the unit before cleaning by hand.
• Do not use water that is micro-biologically unsafe or of un-
known quality.
• Do not touch the evaporator with your hands while the
ice maker is operating.
• Do not plug in or unplug the unit with wet hands.
• Do not remove any safety, warning, or product information la-
bels from the unit.
• Only responsible and capable adults should operate the ice
maker.
• Do not place the power cord where it could be pulled by children
or pose a tripping hazard.
• Children should not be left unattended near the ice maker during
operation.
WARNING
To reduce the risk of injury or property damage, follow these safety
precautions.

02
• Do not store or use flammable vapors or liquids near the unit.
• Do not immerse any part of the unit in water.
• Do not attempt to disassemble, repair, modify or replace any
part of the ice maker without permission.
WARNING
FIRE OR EXPLOSION HAZARD Flammable Refrigerant
This unit contains an isobutane refrigerant, also known as
R600a, a natural gas with high environmental compatibility.
However, it is also combustible. Adhere to the warnings below to re-
duce the risk of injury or property damage.
1. When handling, installing, and operating the unit, care should
be taken to avoid damage to the refrigerant tubing.
2. Only dispose of the unit according to Federal and Local Reg-
ulations. Contact your local authorities for the environmen-
tally safe disposal of the unit.
3. Keep ventilation openings around the unit’s enclosure clear
of obstruction.
4. Do not place the unit near heat sources such as an oven.
5. Ensure a minimum of three inches of clearance around the
side and back walls of the unit for proper air circulation.
6. Do not place the unit in direct sunlight.
3”
• The unit must be placed and set up according to installation
instructions before use. The unit is for indoor household use
only.

03
1. Removable Top Cover
2. Secondary Water
Reservoir
3. Ice Full Sensor
4. Ice Outlet
5. Water Reservoir
6. Control Panel
7. Air Exhaust Fan
8. Drain Plug
9. Maximum Water Fill Line
10. Filter
11. Ice Basket
12. Ice Scoop
PRODUCT INTRODUCTION
12
11
10
8
9
1
4
3
5
6
2
7
Tip: To pull off the cover, place your fingers
in the opening under the left side.

04
1
2
3
Key (with indicator light)
ADD WATER
ICE FULL
Function
The indicator light turns red when
the water reservoir needs water.
The indicator light turns red when
the ice basket is full.
ICE/CLEAN
CONTROL PANEL INTRODUCTION
1
3
2
Short press the “ICE/CLEAN“
button to turn on the ice maker
and the ring indicator light turns
white.
Short press the “ICE/CLEAN“
button to turn off the ice maker
and the ring indicator light turns red.
The ring indicator light turns red
when the ice maker is in standby
mode. In standby mode, long-
press the “ICE/CLEAN“ button
for 5 seconds and the ice maker
will switch to self-cleaning mode.
The ring indicator light will flash in
white consecutively.

05
BEFORE FIRST USE
Stand upright for 24hrs. Check for accessories.
Missing parts?
Contact us.
1.
Customer Service
USING YOUR ICE MAKER
2.
Use in locations
10°C ~ 32°C. Perfect ice shape.
10°C ~ 32°C
Unstable base.
3. What Not To Do!
No other liquids
(Drinking water only).
Do not use in
high or low temps.
lower than 41°F/5°C
24Hrs
More Cycles = Perfect Shape

06
HOW TO USE YOUR ICE MAKER
Open cover and remove basket.
Ice full and ready when “ICE FULL”
indicator is on.
When “ADD WATER” indicator
is red, add water and press “ICE/
CLEAN”.
Pour water, do not exceed the
“MAX” water mark.
Press the “ICE/CLEAN” button. Wait 6min-8min.
6min-8min
Depending on room
temp and water temp.
4
Do not put your fingers into the ice
outlet. The ice maker will detect
ice is full and stop working. Wait
3 mins before further operation.
21
Refill
3
Done

07
MANUAL CLEANING
SELFCLEANING 15MIN PROCESS
CLEANING AND MAINTENANCE
To keep your ice tasting fresh and the unit looking great, we recom-
mend cleaning the unit once per week.
2
Remove the top
cover and basket.
1
Clean both water
reservoirs using a
soft cloth dampened
with warm water and
vinegar, then rinse
with clean water.
Clean exterior with
cloth and mild
dishwashing soap.
4
Clean exterior with
cloth and mild
dishwashing soap.
4
Remove the
basket and
add water up
to the “MAX”
water level.
1
In Standby Mode
Hold for 5 sec to
start self-cleaning.
2
=5s
Drain excess water
over sink.
Drain Plug
60mm
Working table
3
Drain excess water
over sink.
Drain Plug
60mm
Working table
3

08
Model SLIM17B/SLIM17G1/
SLIM17G SLIM17T
Voltage/Frequency 115V/60Hz 115V/60Hz
2.7A 2.7A
1.1L 1.1L
1.76 lbs (0.8KG) 1.76 lbs (0.8KG)
33 lbs per day 33 lbs per day
Nugget Nugget
17.6 lbs (8KG) 17.6 lbs (8KG)
ABS, PP ABS, PP, Stainless Steel
11.3 x 8.66 x 12.68 inch
(287 x 220 x 322mm)
11.3 x 8.66 x 12.68 inch
(287 x 220 x 322mm)
Ice-making Current
Water Reservoir
Ice Basket Capacity
Ice-making Rate
Ice Shape
Net Weight
Material
Product Size
• Do not use organic solvent, boiled water, detergent, strong acid and
strong alkali etc. for cleaning.
• When the unit is not to be used for a long duration, drain the water
completely & dry the interior.
• Store in a well ventilated area.
DO’s & DON’Ts while cleaning and maintaining
PRODUCT SPECIFICATIONS

09
TROUBLESHOOTING
Problem
“ICE FULL”
light is on.
“ADD
WATER”
light is on.
Possible Causes Solution
Low water level or not
enough water.
There is too much ice.
Refrigeration system
malfunctions.
If there are no ice
cubes, there may be an
obstruction or the inner
wall needs cleaning.
Stop making ice, refill
water, press “ICE/CLEAN”,
then restart and try again.
Remove some ice.
Please contact customer
service.
Remove the obstruction
inside or clean the inner
wall of the ice storage.
Ring
indicator
light flashes
in red.
Making Ice
too slowly.
The ambient
temperature or the
water temperature in the
inner tank is too high.
Please run the ice maker
when the ambient
temperature is below 90°F
and pour colder water into
the tank.
Press the ICE button twice
to restart the ice-making
program. If this problem
shows up again. Please
contact the customer
service.
Hot air outlet must be
guaranteed to have
more than 5.9 inches of
ventilation distance.
Water temperature
requirement between 7°C -
32°C.
The pipe in the cooling
system is blocked.
Hot air outlet has been
blocked by something.
The water temperature
in the inner tank is too
high.
Refrigerant liquid
leakage.
The cover motor is
broken.

10
Problem
Water
leakage.
Possible Causes Solution
The drain plug is not in
place.
Pipe joints in the
appliance may loose.
The seal has reached the
end of its service life.
Put the drain plug in place.
Please contact customer
service.
860-00640-00 Rev01
To provide customers with a quality shopping and user experience,
the unit can be replaced or returned for a full refund within the 30-day
period from the date of purchase.
After the 30-day warranty has expired, a 1-year warranty from the
date of purchase that covers product replacement is automatically
activated. Please note that proof of purchase is required for all
warranty claims.
This warranty does not cover:
- Any condition resulting from incorrect or inadequate maintenance or care.
- Damage resulting from misuse, abuse, negligence, accidents, or
shipping damage.
- Dissatisfaction due to buyer’s remorse.
- Normal wear and tear.
- Damages incurred after initial transportation.
30-DAY LIMITED WARRANTY
30-DAY TO 1-YEAR LIMITED WARRANTY
30-DAY TO 1-YEAR WARRANTY LIMITATIONS
SHORT AND LONG-TERM WARRANTY
INFORMATION