Silonn SLIM09B User manual

1
SLIM09B / SLIM09T
SLIM09W / SLIM09G1
Ice Maker
[e-mail] 877-546-8603
INSTRUCTION
MANUAL
Rev00(A)

CONTENTS
IMPORTANT SAFETY INFORMATION ............................ 01
PRODUCT INTRODUCTION ......................................... 03
CONTROL PANEL INTRODUCTION ........................................ 04
USING YOUR ICE MAKER ..................................................... 05
CLEANING AND MAINTENANCE ....................................... 07
PRODUCT SPECIFICATIONS ......................................... 08
TROUBLESHOOTING .................................................. 09
SHORT AND LONGTERM WARRANTY INFORMATION ........ 12

01
IMPORTANT SAFETY INFORMATION
• Voltage power from outlet must match specifications on
appliance nameplate.
• This appliance must be grounded.
• Using an extension cord may cause overheating and increase
the risk of fire.
If an extension cord MUST be used:
1) Only use an extension cord with grounding plug.
2) The marked rating of an extension cord must be equal to or
greater than the rating of this appliance.
• Do not operate if any component, including the cord or plug, is
damaged.
• Unplug the unit before cleaning by hand.
• Do not use water that is micro-biologically unsafe or of un-
known quality.
• Do not touch the evaporator with your hands while the
ice maker is operating.
• Do not plug in or unplug the unit with wet hands.
• Do not remove any safety, warning, or product information la-
bels from the unit.
• Only responsible and capable adults should operate the ice
maker.
• Do not place the power cord where it could be pulled by children
or pose a tripping hazard.
• Children should not be left unattended near the ice maker during
operation.
WARNING
To reduce the risk of injury or property damage, please follow these
safety precautions.

02
• Do not store or use flammable vapors or liquids near the unit.
• Do not immerse any part of the unit in water.
• Do not attempt to disassemble, repair, modify or replace any
part of the ice maker without permission from Silonn or its af-
filiates.
WARNING
FIRE OR EXPLOSION HAZARD Flammable Refrigerant
This unit contains an isobutane refrigerant, also known as
R600a, a natural gas with high environmental compatibility.
However, it is also combustible. Adhere to the warnings below to re-
duce the risk of injury or property damage.
1. When handling, installing, and operating the unit, care should
be taken to avoid damage to the refrigerant tubing.
2. Only dispose of the unit according to Federal and Local Reg-
ulations. Contact your local authorities for the environmen-
tally safe disposal of the unit.
3. Keep ventilation openings around the unit’s enclosure clear
of obstruction.
4. Do not place the unit near heat sources such as an oven.
5. Ensure a minimum of three inches of clearance around the
side and back walls of the unit for proper air circulation.
6. Do not place the unit in direct sunlight.
3”
• The unit must be placed and set up according to installation
instructions before use. The unit is for indoor household use
only.

03
PRODUCT INTRODUCTION
1. Large Viewing Window
2. Ice Full Sensor
3. Ice Shovel
4. Maximum Water Fill Line
5. Air Exhaust Fan
6. Control Panel
7. Handle
8. Drain Plug
9. Ice Basket
10. Ice Scoop
1
4
37
8
10
9
5
6
2

04
5
1
2
3
4
6
Key (with indicator)
ADD WATER
ICE FULL
S
L
SELECT
Function
The indicator light turns red when the
water reservoir needs water.
The indicator light turns red when the
ice basket is full.
The indicator light turns green when
large ice mode is selected.
The indicator light turns green when
small ice mode is selected.
Short press the “ON/OFF/CLEAN“
button to turn on the ice maker and the
“POWER“ indicator light turns green.
Short press the “ON/OFF/CLEAN“ but-
ton to turn off the ice maker and the
“POWER“ indicator flashes in green.
When the ice maker is in standby mode,
long-press the “ON/OFF/CLEAN“
button for 5 seconds and the ice maker
will switch to self-cleaning mode.The
indicator lights of “S“ and “L“ will flash
in green consecutively.
Confirming large ice mode or small ice
mode.
ON/OFF
CLEAN
1
5 6
2 3 4
CONTROL PANEL INTRODUCTION

05
USING YOUR ICE MAKER
Stand Upright for 24Hrs Check for Accessories
Missing Parts?
Contact Us.
1.
Discard first 4 cycles
of ice
2.
Use in locations
10°C ~ 32°C Perfect Ice Shape
Customer Service
Note: If not
used in a long
period, discard
first 4 cycles
of Ice. More Cycles = Perfect Shape
10°C ~ 32°C
24Hrs
Position the handle
over the insert hole.
3. Installing The Handle
Fit the handle into
the insert notch.
Lift back to lock into
place.
BEFORE FIRST USE

06
Unstable base.
4. What Not To Do!
No other liquids
(Drinking water only).
Do not use in
high or low temps.
lower than 41°F/5°C
HOW TO USE YOUR ICE MAKER
Open cover and
remove basket.
Press “SELECT” to choose ice cube size.
Ice full and ready when “ICE FULL”
indicator is on.
When “ADD WATER” indicator is
red, add water and press “ON/OFF”.
Pour water, do not exceed
the “MAX” water mark.
Press the “ON/
OFF” button.
Wait 6min-13min.
SMALLLARGE
4
6min-13min
Depending on room
temp and ice size.
5
3
Done
12
Refill

07
CLEANING AND MAINTENANCE
To keep your ice tasting fresh and the unit looking great, we recom-
mend cleaning the unit once per week.
Clean using a soft
cloth with warm
water and vinegar,
then rinse with clean
water.
2
MANUAL CLEANING
SELFCLEANING 30MIN PROCESS
Drain excess water
over sink.
Drain Plug
60mm
Counter
3
Drain excess water
over sink.
Drain Plug
60mm
Counter
3
In Standby Mode
Hold for 5 sec to
start self-cleaning.
2
=5s
Remove the
basket.
1
Clean exterior with
cloth and mild dish-
washing soap.
4
Clean exterior with
cloth and mild dish-
washing soap.
4
Remove the
basket and
add water.
1

08
PRODUCT SPECIFICATIONS
Model SLIM09B/SLIM09W/
SLIM09G1 SLIM09T
Voltage/Frequency 115V/60Hz 115V/60Hz
1.5A 1.5A
1.8A 1.8A
≤160W ≤160W
1.2L (0.32gal)
1.32 lbs (0.6KG) 1.32 lbs (0.6KG)
1.2L (0.32gal)
26 lbs per day 26 lbs per day
Bullet Bullet
Small or Large Small or Large
ABS, PP ABS, PP,
Stainless Steel
Ice-making Current
Ice-harvesting Current
Working Power
Water Reservoir
Ice Basket Capacity
Ice-making Rate
Ice Shape
Ice Size
Material
• Do not use organic solvent, boiled water, detergent, strong acid and
strong alkali etc. for cleaning.
• When the unit is not to be used for a long duration, drain the water
completely & dry the interior.
• Store in a well ventilated area.
DO’s & DON’Ts while cleaning and maintaining

09
TROUBLESHOOTING
Problem
Poor ice
shape or
quality.
Possible Causes Solution
Poor heat dissipation.
The water temperature
is too high.
The ambient
temperature is too high.
Evaporator
deformation
Leave a 6-inch clearance
on all sides of the ice mak-
er for ventilation.
Fill with water temperature
between 8°C and 25°C.
Use the ice maker in room
temperatures between
10°C and 32°C.
Please contact customer
service.
Please contact customer
service.
Clean every 1 to 2 weeks,
using some neutral
cleaning agents (such as
mild vinegar solution and
soapy water etc.)
Ice maker
creating loud
noise.
Ice maker has not been
cleaned for a long time,
which will form a sticky
substance around the
inlet of the water pump.
Lack of water to pump
will create noise when
pumping water.
Fan or ice maker is
damaged.
Water pump is
damaged.
Add more water.

10
Problem
“ICE FULL”
light is on.
Ice sticks
together.
Possible Causes Solution
Ice is blocking the
infrared sensor.
Making ice takes too
long.
The water temperature
is too low.
Infrared sensors do not
work.
Evaporator
deformation.
1. Wipe clean the infrared
sensors.
2. Contact customer ser-
vice if the infrared sen-
sors still don’t work.
Empty the ice basket.
Stop making ice, after the
ice melts restart and try
again.
Fill with water tempera-
tures between 8°C and
25°C.
Ambient or water
temperature is too high.
Water pump is
damaged.
The gears in the motor
are broken.
Refrigerating system
blocked.
Refrigerating system
leaking.
The fan stopped working.
The wires are loose.
Please contact customer
service.
Please contact customer
service.
Not making
ice.
Keep ambient temperature
less than 32°C and fill with
cold water.

1111
Problem
“ADD
WATER”
light is on.
Possible Causes Solution
Low water level or not
enough water.
Water screen blocked at
the bottom of the water
reservoir.
Water detector
malfunction.
Pump malfunction.
Stop making ice, refill
water, press “ON/OFF”,
then restart and try again.
Start the self cleaning
function.
Please contact customer
service.

12
To provide customers with a quality shopping and user experience,
the unit can be replaced or returned for a full refund within the 30-day
period from the date of purchase.
After the 30-day warranty has expired, Silonn automatically activates
a 1-year warranty from the date of purchase that covers product
replacement. Please note that proof of purchase is required for all
warranty claims.
This warranty does not cover:
- Any condition resulting from incorrect or inadequate maintenance or care.
- Damage resulting from misuse, abuse, negligence, accidents, or
shipping damage.
- Dissatisfaction due to buyer’s remorse.
- Normal wear and tear.
- Damages incurred after initial transportation.
30-DAY LIMITED WARRANTY
30-DAY TO 1-YEAR LIMITED WARRANTY
30-DAY TO 1-YEAR WARRANTY LIMITATIONS
SHORT AND LONG-TERM WARRANTY
INFORMATION

13

14860-00863-00 Rev00
All of us at Silonn do appreciate your ice maker purchase. We hope
that you are as happy with the ice maker as we were designing and
manufacturing it for you. We strive to provide you with the best quality
ice makers and services in the industry.
Thank You
for Choosing Silonn!
Questions or Problems?
[e-mail]
877-546-8603