Simpli Home AXCMRURBB-2230 User manual

MIRROR
1/10

3/10
IMPORTANT : Please read this manual carefully before beginning
assembly of this product. Keep this manual for future reference.
SAFETY INFORMATION
Identify all the parts and hardware. Do not discard of the packaging until
you have checked that you have all of the parts and hardware required.
Hardware package may have spare parts.
WARNING: This item contains small parts which can be swallowed by
children and pets. Keep children and pets away during assembly.
To avoid danger of suffocation, always keep plastic bags away from
children and pets.
We recommend that you assemble this unit on a carpeted floor to avoid
scratches.
May require 2 people for ease of assembly.
CARE and MAINTENANCE
For regular cleaning, use a damp cloth with warm water, rinse and dry
thoroughly to prevent streaks.

4/10
PRE-ASSEMBLY INFORMATION
1 2
PARTS DESCRIPTION
MIRROR
QTY 1
3
WALL ANCHOR
QTY 2
SCREW
QTY 2

ASSEMBLY
5/10
STEP 1 Determining Measurements
NOTE: Do not mount the mirror directly onto the vanity surface or back splash.
A minimum gap of 10 mm must be left on the top of the vanity.
• Lay the Mirror (1) face down on a soft no scratch surface.
• Measure the distance from the top of the Mirror to the top of the slot
of the Mirror bracket. Record this measurement (Measurement A).
• Mark the vertical centerline of the Mirror.
• Determine the height of the mirror noting where the top edge of the
Mirror will be. Record this measurement (Measurement B).

6/10
ASSEMBLY
STEP 2 Measuring Mirror Placement
• Subtract Measurement A from Measurement B to get Measurement C
(this will give the height position of the Screws (3) on the wall).
• On the vertical center line mark Measurement C.
• Use a level to draw a horizontal line.
• Measure the center distances between the Mirror brackets on the rear
of the Mirror.

7/10
ASSEMBLY
STEP 3 Drilling Holes in the Wall
• Take the measurement distance between the mirror brackets and
divide by 2.
• Mark this dimension on both sides of the center line and on
the horizontal line.
• Drill 8 mm pilot holes into the wall.
WARNING: When drilling the holes in the wall, please be sure to avoid any
internal cables and pipelines.

8/10
ASSEMBLY
STEP 4 Hanging the Mirror
• Tap the Wall Anchors (2) into the holes and insert the Screws (3) leaving
5 mm of the Screw exposed.
• Lift the Mirror above the Screws (3) at an angle and align with the clips.
• Reduce the angle of the Mirror to the wall and slide it down so the
Mirror brackets catch the mirror clips.

9/10
ASSEMBLY
STEP 5 Securing the Mirror
• Check that the Mirror clips are secured in the Mirror brackets.

10/10
WARRANTY
Thank you for purchasing a product. These products have been made to
demanding, high-quality standards and are guaranteed for domestic use
against manufacturing faults for a period of 12 months from the date of
purchase. This warranty does not affect your statutory rights.
We reserve the right to repair or replace the defective product, at its
discretion.
This product is guaranteed for 12 months if used for normal purposes. Any
warranty is invalid if the product has been overloaded or subject to
neglect, improper use or an attempted repair by other than an authorized
agent. Heavy-duty or daily professional/commercial usage are not
guaranteed.
Due to continuous product improvement, we reserve the right to change
the product specifications without prior notice.