SINGULARITY COMPUTERS SPECTRE 3.0 ENTERPRISE User manual

vv
Revision 1.0

Spectre 3.0 Enterprise
Second PSU Mount Manual
Revision 1.0
Page | 1
Introduction
The Spectre 3.0 Enterprise Second PSU Mount adds a secondary PSU mounting location at the
front of the case. A front mounted radiator cannot be used when a second PSU is installed but
Spectre 3.0 Enterprise has 5x 360mm radiator mounting positions and 3 of those are also
compatible with the MO-RA 360. The second PSU is intended for when multiple GPUs are used
and is for powering the GPUs, which means the cable runs can be clean with custom cables
running directly into the GPUs. A 90-degree PSU power cable is included so that it can be routed
under the case.
Specifications & Included Items
Included Items
Spectre 3.0 Enterprise 2nd PSU Mount.
90 Degree PSU Power Cable 600mm.
Fasteners Stainless Steel. M4 x 12mm x 2. M4 Nuts x2.
Materials CNC machined cast acrylic.
Manufacturing Process CNC Router. 3D Printer.
Assembly
•Remove the PSU Bottom Shroud and replace it with the Spectre 3.0 Second PSU Mount.
•PSU support marked 1can be moved to
different locations depending on your PSUs
connector and switch locations.
Support Strut marked 2is an optional item
for builds with multiple GPUs and an extreme
amount of weight.

Spectre 3.0 Enterprise
Second PSU Mount Manual
Revision 1.0
Page | 2
•Attach the Spectre 3.0 Enterprise Dual PSU Mount to the Front Panel using the included M4 x
12mm x 2 fasteners. The PSU can be mounted afterward.
•There are 3 extra 2.5" drive locations marked in the diagram below along with the x4 inside of
the PSU shroud.