GENERAL SAFETY WARNINGS
Read all safety warnings and instructions. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury. Save all warnings and instructions for
future reference.
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must be
supplied by the operator. Read carefully and understand all ASSEMBLY AND OPERATION
INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety
precautions may result in serious personal injury.
1
IMPORTANT SAFETY INFORMATION
i) DO NOT operate or assemble the product until they have read this manual and have
developed a thorough understanding of how it works.
ii) Be careful when folding or unfolding legs to prevent any finger pinch points.
iii) Place the stand on a flat and level surface to avoid rocking or tipping of the tool.
iv) Test the setup for stability before starting work.
v) Be sure the mitre saw is tightened securely at all mountings before use.
vi) This stand is designed for use on mitre saws with a blade diameter not larger than 12
inch.
vii) Do not apply an unbalanced load which could cause the miter saw stand to tip over.
SAVE THESE WARNINGS
Danger / Caution: Indicates risk of personal injury and/or
the possibility of damage.
SAFETY SYMBOLS USED THROUGHOUT THIS MANUAL
Note: Supplementary information.
SAFETY INSTRUCTIONS
