iDOL 65 camera mounting kit
Mounting Guide 5
3.2 Placement
iDOL 65 must be mounted above the feed dispenser at dry feeding as shown in Figure 1 or above the drinking
nipple at wet feeding as shown in Figure 2.
The distance to the floor should optimally be 2300 mm and must not deviate more than +/- 50 mm.
The house must be emptied and cleaned when the cameras are mounted. There must not be any deposits on
the floor which could make the measurement of the distance to the floor inaccurate.
No.: Description: Value: Tolerance:
1 The box front must be facing the pen floor. The camera must be
hung horizontally, parallel to the floor.
0° +/- 4°
2 Height above the floor (measured from the front of the box) 2300 mm +/- 50 mm
3 Distance from pen wall / center of the feed dispenser 700 mm +/- 100 mm
4 Center the box compared to the center of the feed dispenser 0 mm +/- 300 mm
5 The hinge of the box must face the feed dispenser and must be par-
allel to the partition wall
0° +/- 10°
Table 1: Demands for correct iDOL 65 mounting.
2300 mm
700 mm
1400 mm
2390 mm
Make sure that no pipes, wires, etc. are occluding
(blocking) the camera view. This means that no
elements (such as feed lines) must be placed in
the hatched field.
The mounting should be done in a manner that
minimizes any movement and vibrations.
The cameras must be mounted in pens where no
sunlight occurs.
