skyinnov M300 User manual

1
Manual_Pack-M300_en_V1
EN
Installation manual
Trichogramma Pack
M300

2
Manual_Pack-M300_en_V1
Summary :
1. Introduction ________________________________________________ p3
2. Assembly___________________________________________________ p4
3. Setup______________________________________________________ p8

3
Manual_Pack-M300_en_V1
Introduction :
The trichogramma pack for DJI Matrice 300 is composed of the following elements:
-The Trichogramma system T-Drop and its 8 liter tank
-The T-Box System
-The supports of fixations necessary for its installation
-A raised landing gear
This manual is intended for the assembly of the pack,
For the use of the spreader and the autonomous system please refer to their manual:
- T-Drop Manual
- T-Box Manual

4
Manual_Pack-M300_en_V1
Assembly :
1) Assembling the lower attachment point on the T-Drop:
Remove the two M3x6 FHC screws under the screen and replace
them with the two M3x10 BHC screws provided to secure the carbon
plate of the bottom bracket.

5
Manual_Pack-M300_en_V1
2) T-Box assembly and top mount on the T-Drop :
Use the 4 supplied M3x15 CHC screws to mount the T-Box to the
spreader tray by sandwiching the carbon plate of the bracket.
(The antennas must be opposite to the screen)
Fix with the 4 supplied M3 nuts from the inside of the tank.
(The 4 holes in the tank may need to be enlarged to 3.5mm)

6
Manual_Pack-M300_en_V1
3) Cable attachment :
Attach the cable to the bracket using the supplied cable tie.
Do not run the cable over the GPS
Then check that the cable cannot pass through the propeller.

7
Manual_Pack-M300_en_V1
4) Assembly on the M300:
For more ease, the assembly is done with the M300 upside down
as for the DJI payload.
-Slide the spreader between the two legs until it rests on the stops.
-Clip the bottom bracket onto the tube.
-Close the two upper brackets and lock them with the hand screws provided.

8
Manual_Pack-M300_en_V1
Setup :
To work with the T-Box, your T-Drop spreader must follow this configuration:
ARM : off
DROP mode : I/0
This manual is intended for the assembly of the pack,
For the use of the spreader and the autonomous system please refer to
their manual:
- T-Drop Manual
- T-Box Manual