skyinnov T-Box User manual

1
Manual_T-Box_EN_V1
EN
T-Box
User’s manual

2
Manual_T-Box_EN_V1
Contents :
1. Setup _____________________________________________________ p3
2. Connection ________________________________________________ p5
3. Menu ____________________________________________________ p6
4. Configuration ______________________________________________ p9

3
Manual_T-Box_EN_V1
Setup :
The T-Box is mounted on your spreader using the M3 screws supplied with the
spreader.
Two lengths are supplied, the 3 long screws are used in the plastic housing.
The socket for the T-Box battery must be on the screen side of the T-Drop.
The tank of your spreader is pre-drilled to accommodate the T-
Box, simply enlarge the 4 central holes of the tank to 3 / 3.5mm
(see diagram page 4)

4
Manual_T-Box_EN_V1
3 / 3.5mm

5
Manual_T-Box_EN_V1
Connection :
-- Connect the spreader plug to the T-Box.
-For the power supply of the T-Box you have two options:
•Connect a 5V power supply (2amps mini) to the "5V In" input
which is located next to the spreader's socket.
Polarity: - +-
•Supply the T-Box with a 2S battery via the XT30 socket
(Recommended battery: 2S li-ion 4800Mah)
In this case, you will have to use the power button to switch on the
T-Box.
The T-Box remote control is charged via the micro usb plug.
A red light indicates charging and goes out when charging is complete.
The battery of the remote control discharges automatically when not in
use, so we advise you to recharge the remote control just before use.

6
Manual_T-Box_EN_V1
Menu :
Main page :
When you start your T-Box remote control, the screen displays the Skyinnov logo for a
few seconds and then you arrive on the main page:
- Long press Down button=> On / Off
(the remote control cannot be turned off if the spreader is running)
- Long press right button=> next page
Short press right button=> stop spreader
- Long press left button => previous page
Short press left button=> spreader on
State of the spreader
Number of satellites
Only visible in Gps mode.
Spreader will not start if
less than 6 satellites
T-Box battery
We recommend a
minimum of :
- 30% for a li-po battery
- 10% for a li-ion battery
The display is only an
indication, you must
regularly check the level
of your battery with a
suitable tester.
Number of balls
dropped
A long press on the
right and left button
simultaneously resets
the counter to zero.
Radio control battery
Radio signal status

7
Manual_T-Box_EN_V1
GPS page :
- Long press Down button=> On / Off
- Long press right button=> next page
Short press right button=> next value
- Long press left button => previous page
Short press left button=> previous value
Available settings:
- 1 ball every 5 metres
- 1 ball every 10 metres
- 1 ball every 15 metres
- 1 ball every 20 metres

8
Manual_T-Box_EN_V1
Timer page :
- Long press Down button=> On / Off
- Long press right button=> next page
Short press right button=> next value
- Long press left button => previous page
Short press left button=> previous value
Available settings:
- 1 ball every 0.5 second
- 1 ball every 1 second
- 1 ball every 2 seconds
- 1 ball every 3 seconds

9
Manual_T-Box_EN_V1
Configuration :
To work with the T-Box, your T-Drop spreader must follow this configuration:
ARM : off
DROP mode : I/0