skyvoe NXG-42 User manual

Table Stand
Installation
NXG-42 / NXG-46
*This Installation requires a minimum of two people.

3
InstallatIon ManualnXG 42 / nXG 46 |
Lay the television viewing side down on blanket.
Lay blanket down on at
sturdy surface. Run hand over
surface to make sure there
are no sharp object or
protrusions, when the
television is laying down.

4All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Stand
Remove: 2 - M6X12 screws, #8-23 screws, and washers indicated with red
circles.
Left Right
Place mounting plate on your tabletop. Use 4 holes indicated by the red
circles/arrows to drill holes in your table top surface. Insert the fasteners
that you have purchased and tighten securely.

5
InstallatIon ManualnXG 42 / nXG 46 |
With help from a friend align the holes of the table stand with the holes on
the back of the television.
TABLE STAND
The following holes are used to mount the
table stand to the back of the television.

6All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Stand
Reinsert the screws with the at washers and tighten securely.
*Be sure not to over tighten.
Congratulations you have successfully installed your
table stand. If you have any questions call our tech
support team
(877)-475-9883 option 2