SLIGH 9601 User manual

Sligh Furniture Company Holland, Michigan www.sligh.com 1/06 352-9601
Installation Instructions
9601 Entertainment Cabinet

Step 1
Attaching Side Cabinets to the Center Cabinet
Align the side cabinets next to the center cabinet. Level the side cabinets front to
back and side to side by utilizing the wrench accessed levelers located inside the
drawer cavities at four corners. Remove the lower drawer prior to leveling. To remove
the drawer: face the drawer and flip the left side tab up and the right side tab down
then pull.
Insert 3 Allen head bolts (provided) through the 3 attachment holes in the end panels
of the side and center cabinets. Attach a Allen head nut (provided) to the opposite
end of the bolts and tighten with the Allen head wrench (provided.)
Step 2
Connecting Cabinet to Cabinet Display Lights
Once the center and side cabinets are connected to each other and in their final
position against the wall retrieve a step ladder to access the back edge of the top.
Position the step ladder in front near the point where a side cabinet meets the center
cabinet.
Retrieve the 60 inch long “jumper cable” (enclosed in the RH side cabinet drawer).
Place the ends of the “jumper cable” into the wire management clips located behind
the top at both ends of the center cabinet.
Connect one end of the “jumper cable” to the end of the
light cord exiting the top back edge of the RH side cabinet.
Connect the other end of the “Jumper Cable” to the end of
the light cord exiting the back of the LH cabinet.
Place the center cabinet near it’s final destination.
Locate the surge suppressor power cord and co-ax cable cord behind the lower doors
of the center cabinet. Feed these cords through the outlet hole in the back panel.
Plug the power cord into a nearby wall outlet and one end of the co-ax cable into a
nearby cable TV wall outlet.
Locate the power cord plug for the display lights attached to the back edge of the RH
facing center cabinet end panel. Plug this power cord into a nearby electrical outlet.
Slide the center cabinet into it’s final resting place and level the cabinet front to back
and side to side by utilizing the wrench accessed levelers located inside the door cavi-
ties at four corners and a center point.
The display lights are touch activated. To activate touch the small brass plate located
behind the RH pilaster of the center cabinet. Touch once to turn the lights on, touch
a second and third time to increase light intensity. A fourth touch will turn the lights
off. Repeat this process to re-activate the display lights.