Smart Lan PW54 User manual

WIRELESS PCIADAPTER 54Mbps
USER MANUAL
PW54 (802.11b/g)
Easy to install
and configure

PW54 11G Wireless PCI Adapter
www.smartlan.us 1
Ralink PCI Wireless LAN Adapter User’s Manual
1 Install the driver
aInsert the installation CD into your CD-ROM driver, Double click the icon
tostartsetup
b click Yes to go on
c
d click Finish to end the setup

PW54 11G Wireless PCI Adapter
www.smartlan.us 2
2 Turn off your computer, Plug in your PCI wireless LAN adapter, and then turn
on your computer. it will be recognized and auto installed. Just confirmed it like
below:
3 Make infrastructure connection
¾Double click the icon in red circle
¾You will see:

PW54 11G Wireless PCI Adapter
www.smartlan.us 3
¾You can click the button Rescan to find which AP is in range, they will show on
the window, choice one you want to connect, and click the button connect, and
click ok to finish the connection operation.
¾An infrastructure connection is accomplished.
¾Note, please choose correct channel setting up to your law, for example, ch13 is
permitted in your country, and you set your router at ch13, while you choose
ch1-ch11 (default setting), you will never find the AP, and you will have to
choose ch1-ch13 setting in Advanced page as below
4 Some help information in Rlink Wireless Utility
zHow to find out your IP address:

PW54 11G Wireless PCI Adapter
www.smartlan.us 4
How to find out which a WIFI environment you are inside
5 Make Ad-Hoc mode connection
z5.1 Make an Ad-Hoc SSID

PW54 11G Wireless PCI Adapter
www.smartlan.us 5
A
B
C

PW54 11G Wireless PCI Adapter
www.smartlan.us 6
D
5.2 Setup static IP address for the Ad-Hoc link
¾AAt its property page, double click item Internet Protocol (TCP/IP)

PW54 11G Wireless PCI Adapter
www.smartlan.us 7
B You will get
C Fill the IP address blank, example as below:

PW54 11G Wireless PCI Adapter
www.smartlan.us 8
D Click ok to finish the setup
z5.3 Ad-Hoc setup for one point accomplished
z5.4 Setup another Ad-Hoc point as step A,B,C,D.
z5.5 Ad-Hoc mode link accomplished. And you can visit each other.
Note: To make an Ad-Hoc mode link, Do remember to choice the same
channel, its static IP address should be in the same netsub, and the SSID
should be the same too.

www.smartlan.us