TRENDnet Te100-pciwn User manual

Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TE100-PCIWN
Version 06.14.05
32-bit PCI 10/100Mbps N-way Fast Ethernet Card
Quick Installation Guide
Card 32-bit PCI 10/100Mbps N-way Fast Ethernet cu ACPI Wake-on-LAN
Ghid de instalare in limba romana

Table of Contents
English ............................................................................................
Românǎ ...........................................................................................
Troubleshooting................................................................................
1
1
2
3
7
7
8
9
13
1. Prepare for Installation ............................................................
2. Install Hardware ......................................................................
3. Install Drivers ...........................................................................
1. Pregatiti-va pentru instalare ....................................................
2. Instalare fizica .........................................................................
3. Instalare drivere .....................................................................

Thank you for purchasing TRENDnet's TE100-PCIWN network adapter. Your
new network adapter will allow you to connect to a Cable/DSL modem for
broadband Internet access or share Internet access, files, and other resources
on a 10/100Mbps Fast Ethernet network.
This guide will help you set up and configure your TE100-PCIWN network
adapter. Following this installation should be quick and easy. If you run into
problems, please refer to the Troubleshooting section at the end of this guide. If
you need further technical support, please visit www.TRENDNET.com or call
technical support by phone.
Verify Package Contents
Please make sure you have everything in the box:
Driver Diskette Quick Installation Guide
TE100-PCIWN
1
1. Prepare for Installation
English QIG
English
Verify Equipment
Before installing this adapter, you should have:
1. A Computer with an available 32-bit PCI slot
2. A 300 MHz processor and 32 MB RAM on your computer (Recommended)
3. Windows 98/98SE/ME/2000/XP/2003 installed on your computer
4. A RJ-45 Ethernet cable
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TE100-PCIWN
Version 06.14.05
32-bit PCI 10/100Mbps N-way Fast Ethernet Card
Quick Installation Guide
Card 32-bit PCI 10/100Mbps N-way Fast Ethernet cu ACPI Wake-on-LAN
Ghid de instalare in limba romana

2
2. Install Hardware
Install Network Adapter
1. Shut down your computer.
2. Open your computer case to reveal the motherboard and expansion slots.
(Please refer to your computer's user manual if you need help opening the
case)
3. Insert the TE100-PCIWN network adapter into one of the motherboard's free
PCI slots. Press down firmly and evenly on the card until it snaps into place.
4. Screw the PCI card's metal bracket into your case with a standard bracket
screw.
5. Close your computer case, and reboot your computer.
6. Connect your RJ-45 Ethernet cable to the TE100-PCIWN's Ethernet port and
to the existing 10/100Mbps Fast Ethernet network or Cable/DSL modem.
7. Turn on your computer.
English

3
3. Install Drivers
1. After your computer reboots, the “Add New Hardware Wizard” will appear.
Click Next.
2. Insert the included TE100-PCIW Series Driver Diskette into your computer's
floppy-drive. Verify that Search for the best driver for your device is
selected, and click Next.
3. Select Specify a location, and click Browse.
English
Install Network Adapter

4
5. Click Next.
English
4. Double-click your floppy-drive (i.e.: 3 1/2 Floppy (A:)). Select the folder
named Win98, and click OK.

5English
6. Once the Wizard tells you it's “ready to install the best driver,” click Next to
begin installing the driver.
7. You may be asked to insert your Windows 98 CD-ROM. If this happens,
insert your Windows 98 CD-ROM into your CD-ROM drive, and click OK.
8. Click Finish to complete the driver installation.

6English
9. Click Yes. Your computer will be updated with the new settings.
1. Windows will automatically detect and install the appropriate driver for your
network adapter.
Note: If this prompt does not appear, you must manually restart your
computer.
Windows ME/2000/XP
Congratulations!
Installation is now complete.

Inaintea instalarii acestui adaptor, ar trebui sa aveti:
1. un computer cu un slot PCI 32-bit liber
2. un procesor 300 MHz si 32 MB RAM in computer (recomandat)
3. Windows 98/98SE/ME/2000/XP/2003 instalat pe computer
4. un cablu de Ethernet RJ-45
Va multumim ca ati cumparat adaptorul de retea TE100-PCIWN de la
TRENDnet. Noul dumneavoastra adaptor de retea va va permite sa va
conectati la un modem Cablu/DSL pentru acces la Internet broadband sau sa
share-uiti accesul la Internet, fisiere si alte resurse pe o retea 10/100Mbps Fast
Ethernet.
Acest ghid va va ajuta sa setati si sa configurati adaptorul dumneavoastra de
retea TE100-PCIWN. Urmarind acest ghid instalatia va fi usoara si rapida.
Daca aveti nevoie de mai mult ajutor si suport tehnic, va rugam savizitati
www.TRENDNET.com sau sunati suportul tehnic pe telefon.
7
1. Pregatiti-va pentru instalare
Românǎ QIG
Românǎ
Discheta drivere Ghid de instalare
TE100-PCIWN
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TE100-PCIWN
Version 06.14.05
32-bit PCI 10/100Mbps N-way Fast Ethernet Card
Quick Installation Guide
Card 32-bit PCI 10/100Mbps N-way Fast Ethernet cu ACPI Wake-on-LAN
Ghid de instalare in limba romana
Verificarea Echipamentului
Continutul Pachetului
Va rugam asigurati-va ca aveti urmatoarele in cutie:

2. Instalare fizica
Instalati adaptorul de retea
1. Opriti computerul.
2. Deschideti carcasa computerului pentru a capata acces la placa de baza si
la sloturile de extindere. (va rugam sa va referiti la manualul computerului
dumneavoastra daca aveti nevoie de ajutor in manevrarea carcasei)
3. Introduceti adaptorul de retea TE100-PCIWN intr-unul din sloturile PCI libere
de pe placa de baza. Apasati in jos ferm si uniform pe placa pana cand intra
in loc.
4. Fixati cu surub bratul metalic al placii PCI pe carcasa cu un surub.
Inchideti carcasa computerului si restartati computerul.
6. Conectati cablul Ethernet RJ-45 la portul Ethernet al TE100-PCIWN si la
reteaua existenta 10/100Mbps Fast Ethernet sau la modemul Cablu/DSL.
7. Porniti computerul.
8Românǎ

3. Instalare drivere
1. Dupa ce calculatorul dumneavoastra se restarteaza, va apare “Add New
Hardware Wizard”. Dati click pe Next.
2. Introduceti discheta cu drivere seria TE100-PCIW furnizata in floppy-ul
computerului. Asigurat-va ca Search for the best driver for your device este
selectat si dati click pe Next.
3. Selectati Specify a location si dati click pe Browse.
Windows 98/98SE
9Românǎ

5. Dati click pe Next.
4. Dati dublu-click pe unitatea floppy (in general: 3 1/2 Floppy (A:)). Selectati
folderul numit Win98 si dati click pe OK.
10 Românǎ

6. Odata ce Wizard-ul va spune ca este “ready to install the best driver,” adica
“gata sa instaleze cel mai bun driver” dati click pe Next pentru a initia
instalarea driverului.
7. Se poate intampla sa vi se ceara CD-ul Windows 98. Daca se intampla
aceasta, introduceti CD-ul Windows 98 in unitatea CD-ROM si dati click pe
OK.
8. Dati click pe Finish pentru a completa instalarea driverului.
11 Românǎ

9. Dati click pe Yes. Computerul va fi updatat cu noile setari.paramètres.
1. Windows va detecta automat si instala driverul corect pentru adaptarul
dumneavoastra de retea.
Nota: Daca aceasta fereastra de mai jos nu apare, trebuie sa restartati
manual computerul.
Windows ME/2000/XP
Felicitari!
Installatia este acum completata.
12 Românǎ

13
Q1.
A1.
Q2.
A2.
Windows doesn't recognize my new hardware. What should I do?
Go to Start > Control Panel > System > Device Manager. (Start >
Control Panel > System > Hardware > Device Manager in Windows
2000/XP) In the list of device-types, locate and double-click Network
Adapters. If you see a device with a yellow question mark or exclamation
point over it, double-click it. Click the Driver tab, and click Update Driver.
Follow the Hardware Update Wizard's instructions to update your
computer with the driver on the included floppy disk.
If the Device Manager fails to recognize the presence of a new networking
adapter, you should ensure that your network adapter is firmly seated in its
PCI slot. You may also choose to move the adapter to a different PCI slot.
Windows recognizes my new hardware, but I'm unable to connect to
my network. What should I do?
Verify that the RJ-45 Ethernet Cable is securely connected from your
switch/router to your network card and that the TE100-PCIWN or Te100-
PCIWA's link LED is lit. Also, ensure that the TCP/IP settings are set to
Obtain an IP address automatically.
Troubleshooting
If you still encounter problems, please feel free to contact TRENDware's
technical support team.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.

Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
@
TRENDnet
TRENDware, USA
What's Next in Networking
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDware’s website at http://www.TRENDNET.com
TRENDware International, Inc.
3135 Kashiwa Street. Torrance, CA 90505
http://www.TRENDNET.com
TRENDnet Technical Support
Contact
Telephone:
Fax:
Email:
1(310) 626-6252
1(310) 626-6267
[email protected]
Tech Support Hours
7:30am - 6:00pm Pacific Standard Time
Monday - Friday
Tech Support Hours
Telephone
Fax:
Deutsch :+49 (0) 6331 / 268-460
Français :+49 (0) 6331 / 268-461
Español :+49 (0) 6331 / 268-462
English :+49 (0) 6331 / 268-463
Italiano :+49 (0) 6331 / 268-464
Dutch :+49 (0) 6331 / 268-465
+49 (0) 6331 / 268-466
8:00am - 6:00pm Middle European Time
Monday - Friday
US/Canada Support Center European Support Center
Contact