Smart power COPIER GUARDIAN II User manual

USER'S GUIDE
USER'S GUIDE
Thank you for purchasing this Copier Guardian II.
Smart Power Systems is dedicated to developing
and manufacturing the highest performance power
protection and filtration devices for your electronic
equipment. Proper use of this device will provide
the protection needed for your connected
equipment.
COPIER GUARDIAN II
COPIER GUARDIAN II
WITH SMART
GROUND
P.N.16004540 Rev.11/14
ELECTRONIC POWER CONDITIONER

Use this user's guide for the following products:
MODEL / PART NUMBER DESCRIPTION
120V/15A, two 5-15R outlets
120V/15A, ONE 5-15R pigtail outlet, RJ11+RJ45
120V/15A, two 5-15R outlets , RJ11+RJ45
120V/15A, two 5-15R outlets and one 5-15R pigtail outlet, RJ11+RJ45
120V/20A, one 5-20R pigtail outlet
120V/20A, one 5-20R pigtail outlet, RJ11+RJ45
120V/20A, one 5-15R outlet, one 5-20R pigtail outlet, RJ11+RJ45
ZERO CROSS PROTECTION, 120V/15A, two 5-15R outlets, RJ11+RJ45
ZERO CROSS PROTECTION, 120V/20A, one 5-20R outlet, RJ11+RJ45
208V - 240V/15A, one 6-15R pigtail outlet, RJ11+RJ45
208V - 240V/20A, one 6-20R pigtail outlet, RJ11+RJ45
TBF15C-1120
TBF15C-1111TN
TBF15C-1121TN
TBF15C-1131TN
TBF20C-1210
TBF20C-1211TN
TBF20C-1221TN
TBF15CZ-1121TN
TBF20CZ-1211TN
TBF15C-2111TN
TBF20C-2211TN
Modem & Data Protection (model dependent)
Protection is extended to your phone and network lines with the addition of RJ11 and RJ45 jacks
on the Copier Guardian II unit, creating ideal protection for Fax/Internet/Network users. Power
surges can pass to a copier through phones lines and network cables.
CAUTION
CAUTION
CAUTION
CAUTION
• Use only in dry locations indoors.
• Avoid dropping the unit.
• Only plug the Copier Guardian II into a three pronged grounded outlet. This unit is not to be
used with any type of ground “lift” or pin eliminator.
• Do not open the Copier Guardian II unit, there are no serviceable parts inside. Opening the unit
will void your warranty.
This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.
Risk of Electric Shock. Do not plug into another relocatable power tap.
FEATURES
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at [email protected]
•• Utiliser uniquement dans des endroits secs à l'intérieur.
• Évitez de faire tomber l'appareil.
• Brancher le Copier Guardian II en trois volets prise de terre. Cette unité ne doit pas être utilisé
avec tout type de terrain "ascenseur" ou broches éliminateur.
• Ne pas ouvrir l'unité Copier Guardian II, il n'y a pas de pièces réparables. Ouverture de l'unité
annulera votre garantie.
Cet appareil dispose d'une protection interne qui va déconnecter le composant de protection contre
les surtensions à la fin de sa vie utile mais se maintenir au pouvoir à la charge maintenant sans
protection. Si cette situation est souhaitable pour l'application, suivez les instructions du fabricant
pour le remplacement de l'appareil.
Ne pas installer cet appareil si il n'y a pas au moins 10 mètres (30 pieds) ou plus de fil entre la prise
électrique et le panneau de service électrique.
ATTENTION
ATTENTION
ATTENTION
ATTENTION
Risque de choc électrique. Ne branchez pas dans une autre puissance robinet délocalisables.

1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Copier Guardian II .
3. Plug the Copier Guardian II unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Copier Guardian II where monitoring lights can
be observed.
Unit
INSTALLATION OF TBF™
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Connected
Equipment with
Tel./Modem Jack
Power Cord
Power Cord
Pigtail
Outlet
Copier Guardian
Power Cord
Phone Cord
Phone Cord
Network Cord
Network Cord
LINE
LINE
DEVICE
DEVICE
Phone
Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
Installation for Protection for Telephone Line and Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE" on
the Copier Guardian II.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
Telephone Line Protection clamping voltage 250-350 vdc.
NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the Copier Guardian II.
2. Plug the provided network cable to the RJ45 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the network cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the Copier Guardian II where monitoring lights can be observed.
NOTE: All Copier Guardian II units come with security straps,
warning label and Velcro™ to secure unit to connected equipment.
STRAP FOR RECEPTACLE
STRAP FOR PIGTAIL
RECEPTACLE
The label on the security
strap is permanent and
warning: to unplug the unit
will cause the label to tear
out and void the warranty.
IMPORTANT: Velcro™ strips are provided so
Copier Guardian II can be attached to copier
when needed. Do not place Velcro™ over label.
BACK OF UNIT
Provided with
Velcro™ strips
CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
The GREEN light confirms properly the connected equipment is fully protected. The RED light
indicates over voltage, improper ground connection or reversed power wires which needs to
be corrected. In an over voltage incident, power is disconnected to protect the connected
equipment. IMPORTANT: If the RED Light comes on, contact your electrician to inspect
and correct the outlet wiring in order to receive the maximum protection for your connected
equipment.

IMPORTANT
If for any reason you need to return the Copier Guardian II unit to the manufacturer, you
should obtain an RMA (Return Material Authorization) number before returning the unit.
To request an RMA number please call 1-800-772-7633 or visit the website at
www.smartpowersystems.com/main/rma.htm
1760 Stebbins Drive - Houston, Texas 77043 - Tel:[phone] - Fax:[phone]
E-mail: [email protected] - www.smartpowersystems.com 1-800-882-8285
TRANSFORMER BASED FILTER (TBF™) SERIES
Considered to be one of the most significant developments in the power protection industry. TBF™
Filters contain innovative technology that combines Surge Suppression and Noise Isolation which
filters the noise on the ground to less than 0.5 Volts (US Patent # 6229682). Exclusive "POVP"
Prolonged Over Voltage Protector (US Patent # 6560086) disconnects the output power if voltage
exceeds 155 volts. Exclusive Smart Technology (US Patent #5721661) protects microprocessor
based equipment against reverse polarity or no ground. The patented TBF™ filters prevent 90% of
the power problems experienced by your POS system, computer, copier and facsimile machine.
MEGA CONDITIONERS
The most advanced electronic power conditioner on the market for half the price and a
quarter of the weight of an isolation transformer. The Mega Conditioner offers voltage
regulation, ultra power filtration and conditioning of normal and common mode noise which
accounts for 90% of power-related problems experienced by copiers, mailing systems, large
format printers and other office equipment.
AUTOMATIC VOLTAGE REGULATOR - AVR SERIES
Regulates the voltage to protect equipment against voltage sags and brownouts as well as
voltage swells. Electronic systems are designed to operate based on a clean and constant
supply of AC voltage. Smart Power Systems' AVR line provides boost & buck capability to
eliminate under or over voltage fluctuations.
UNINTERRUPTIBLE POWER SUPPLIES - UPS SERIES
Smart Power Systems' Uninterruptible Power Supplies (UPS) with integrated TBF™
Technology provide on-line power conditioning.
OTHER POWER PROTECTION PRODUCTS
WARRANTY
Limited Lifetime Warranty
All Copier Guardian II Filters are guaranteed free of defects in material or workmanship
for the life to the original purchaser --or, they will be repaired or replaced free of charge. See our
website for more details - www.smartpowersystems.com
Series
$25,000 Connected Equipment Warranty
If the Smart Power Systems equipment fails and this failure allows a surge to pass through and
damage the connected equipment, Smart Power Systems will pay for the repair or replacement of
the connected equipment of the original purchaser . See our website for more details -
http://www.smartpowersystems.com/content/main/cepp.html
UL 1449 3rd. Edition Listed
LISTED