SmartH SKCR018H User manual

2.4GHz 5GHz
Please keep network available
Set Up Router
The router supports the 2.4GHz WiFi (doesn't support the
5GHz), and is connected to the WiFi network. Please set the
parameters of the router before connecting the WiFi network,
and record the SSID and password of your WiFi.

Step1:Make sure the power is connected to the fan before
using.Plug the Fan into an AC 110V~50Hz main soutlet.
Step2:Press and hold the power button for 5seconds, Make
the numbers in the display flash quickly(rapid blink)
• The number light rapid blink : Pairing mode to Connect
WiFi.
Ready to work
Manually add Wi-Fi devices in EZ mode

lnstall Free App
Download APP: scan the QR code below to download and
install. Register and login: open the "MySmartH" APP to
register and login according to the prompts.
Customer Support

Manually add Wi-Fi devices in
EZ mode
1. Open "MySmartH" APP, press the'+' in the upper
right comer of the main screen;
2. Choose "Home Appliance"、click "Bladeless Fan
Heater.
1
2
Two pairing modes are provided in the MySmartH app. The Wi-
Fi Easy Connect (EZ) mode is the default mode, and the
access point (AP) mode is the compatible mode. The user can
tap the pairing mode drop-down list in the top-right corner of the
page to switch between the pairing modes.

3. Choose WiFi and enter password and tap “Next”;
4. Confirm that the red indicator light of the water leak
dtetctor is flashing quickly and tap"Next";
34

5. Tap “Done”;
5
Smart Fan

Now your Bladeless Fan Heater is successfully added to
MySmartH app.

Manually add Wi-Fi devices
in AP mode
If a dual-band network that supports both 2.4 GHz and 5
GHz bands is used, the AP mode can be used to add
devices.
In AP mode, follow the instructions to enable the indicator
to blink slowly, select Confirm the indicator is blinking slowly,
and then tap Next.
If the connection fails, please try AP mode

Step1:Let the number Light Flash(blink slowly),If the number
light of the Fan is flashing fast, please continue to press and
hold the Power button until the fast flashing turns to slow
flashing.
Make sure the device's number light is slowly flashing(1 time every
3seconds).
Ready to work
Manually add Wi-Fi devices in AP mode

Manually add Wi-Fi devices in
AP mode
1. Open "MySmartH" APP, press the'+' in the upper
right comer of the main screen;
2. Choose "Home Appliance"、click "Bladeless Fan
Heater.
1
2

3. Choose WiFi and enter password and Tap “Next”;
4. Tap"AP Mode"in upper right screen;
3
4

5. Tap “Next”;
6. Click"SmartLife-1DD4";
5
6
In AP mode, on the Wi-Fi setting page of the mobile
phone, find the Wi-Fi hotspot starting with SmartLife.