placing the console unit in the following areas:
•Direct sunlight and surfaces which radiate and emit heat.
•Near heating and ventilation devices, such as heating ducts or air
conditioners.
•Areas with interference from wireless devices (such as cordless
phones, radio headsets, baby listening devices) and electronic
appliances.
Setting up the Thermo-Hygro Sensor(s)
1. Open the latch at the base of the thermo-hygro sensor.
2. Press the ‘link’ button on the main console.
3. Insert 2 x “AA” size 1.5V batteries (within 30 seconds).
4. Replace the latch and mount unit at desired location.
Placement tips:
•The thermo-hygro sensor should be in an area with free air circulation
and sheltered from direct sunlight and other extreme weather
conditions. Place the unit in a shaded area, such as under a roof.
•Use the wall mount and fittings provided if mounting the unit on a
vertical surface.
•Avoid placing the sensor near sources of heat such as chimneys.
•Avoid any areas which collect and radiate heat in the sun, such as
metal, brick or concrete structures, paving, patios and decks.
•Ideally, place the sensor above natural surfaces such as a grassy
lawn.
•The international standard height for measurements of air temperature
is at 1.25m (4 ft) above ground level.
Setting up the Rain Sensor
1. Unlock the funnel-shaped top of the rain sensor by turning both knobs
on the sides of the rain sensor in an anti-clockwise direction.
2. Press the ‘link’ button on the main console.
3. Lift the top off the base and insert 2x “AA” size 1.5V batteries into the
battery holder (within 30 seconds).
4. Replace the lid and secure into place by turning the knobs clockwise.
