SMC Networks Barricade SMC7908VoWBRA User manual

1. To setup VoIP function, you need to collect VoIP configurations from your VoIP Service Provider:
• Phone number
• Gatekeeper IP address
• Password if security feature is required
Note: Optionally there are “Gatekeeper ID” and “H.323 ID” for additional security
2. Go to web interface under “VoIP” submenu “Port Setting”, change the “Extension Number:” to the phone number
collected from your VoIP Provider, then click “OK”
3. In the VoIP Provider Mode page, put the Gatekeeper IP address into “IP Address:”.
4. “Gatekeeper ID:” and “H.323 ID” are optional if they are available from your VoIP Provider
5. Click “OK” to save changes.
Note: If security feature is required by your VoIP Provider, select the “HMAC-SHA1-96 Authentication Only” mode in the
“Security:” drop-down menu. Also put in password into “Password:” field
6. If you encounter problems after entering the requested
parameters, please do the following:
• verify that the router is online, if not please refer to the
troubleshooting section of the QIG
• if the router is online, you should verify the different VoIP
parameters
• then consult the VoIP status page and write down the error
message
• contact VoIP provider to verify that their server is working
and the parameters are correct, then give them the error
message you get
SMC7908VoWBRA
VoIP Configuration Guide for H.323
SMC7908VoWBRASMC7908VoWBRASMC7908VoWBRA