Smeg GP64ES User manual

5
Description Installation
EN
1 Description
1 Grid
2 Burner cap
2 Installation
Proceed as follows to replace the grids and
burner caps:
1. Pull one of the two horizontal spokes of
the grids upwards to remove them.
2. Remove the burner caps.
3. Fit the EVERSHINE treated burner caps
to the corresponding burners.
4. Position the EVERSHINE treated grids,
taking care that the pins Aline up with
their seats on the hob, then press down
with your palm until they click into place.
The special EVERSHINE treatment
makes the stainless-steel burner
caps and grids highly heat resistant,
preventing yellowing due to high
temperatures.

Cleaning and maintenance
6
3 Cleaning For optimum cleaning without damaging the
treatment, proceed as follows:
1. Pull one of the two horizontal spokes of
the grid upwards to remove it.
2. Remove the burner cap.
3. Wash the removed components, taking
care to remove all stains and encrusted
substances.
4. Dry the components.
5. Reposition the burner caps on their
respective burners; position the grids,
taking care that the pins Aline up with
their seats on the hob, then press down
with your palm until they click into place.
Improper use
Risk of damage to surfaces
• Do not use steam jets for cleaning the
components.
• Use hot or warm water to clean.
• For stubborn dirt, use neutral, non-
abrasive detergents.
• Do not use cleaning products containing
chlorine, ammonia or bleach.
• Use soft materials (cloths, sponges,
chamois) for cleaning and drying.
• Do not use rough or abrasive materials.
• In case of contact with overly harsh
detergents, hard water or spills (cooking
water, sauce, coffee etc.), clean the hob
as soon as it has cooled.
• Never wash in the dishwasher.
Do not use metallic sponges or
sharp scrapers.