Smeg MWTK37L User manual

www.applico.co.nz
Installation Instructions
MWTK37L trim kit
ENGLISH

2
1. DIMENSIONS OF THE BUILT-IN CABINET
1) The dimensions of the cupboard should be as follows.
Width : 570 mm
Height : 430 mm
Depth : at least 550 mm
2) There should be no rear panel on the cupboard behind the microwave oven.
3) There must be a gap of at least 40 mm between the wall and both the shelf and the
back of the cupboard above.
PLEASE READ THESE INSTRUCTIONS CAREFULLY
BEFORE YOU BEGIN!

3
2. Identification of the fittings
3. Trim kit specfications
INSTALLATION GUIDE
Width 596mm
Height 425mm
Depth 22mm(fascia)
NO PARTS CODE PARTS NAME DESCRIPTION Q'TY
13510403200 BODY-KIT STS H/L 1
23511600320 DECORATOR-KIT ABS 4
37125401211 SCREW TAPPING T2S FLT 4x12 MFZN 4
43510318700 BASE-KIT SBHG 1
53512102310 FOOT-BASE-KIT PP 4
67125401211 SCREW TAPPING T2S FLT 4x12 MFZN 4
77112401011 SCREW TAPPING T1 TRS 4x10 MFZN 4
83515103400 SPRING LOCK STS301 4
93516007400 SPECIAL SCREW KOC-6C40 4
10 3516007330 TEMPLATE BASE CABINET PAPER 1
11 3516007310 TEMPLATE *L CABINET PAPER 1
12 3516007320 TEMPLATE *R CABINET PAPER 1

4
INSTALLATION PROCEDURE
1. Draw screw points of the base-kit4
using template-base0on the bottom
of cupboard.
2. Attach 4 foot-base-kit5to the base-
kit4using flat screws6.
3. Drive 4 screws7on the base-kit4at
the drawn points of the cupboard.
PLEASE READ THESE INSTRUCTIONS CAREFULLY
BEFORE YOU BEGIN!

5
4. Draw points of the special screw using template *Lq/*Rwor ruler.
And drive the special screw9.
5. Install microwave oven onto the base-kit4.
6. Install body-kit1:
Insert 4 special screws9into the spring-lock8
attached to the body-kit1.
7. Make sure the power cord is not trapped the oven, and is not in contact with surfaces that
may get hot, or wet.
8. Check the oven is secured in its housing.
9. Remove any protective or publicity material from the oven.
10. Plug the oven into the wall socket.
INSTALLATION GUIDE

INSTALLATION GUIDE
6
ADDITIONAL INFORMATION FOR FLUSH MOUNTING
If the cavity is 600m wide and you wish to mount the trim-kit, you must affix two 15mm battens
to the side walls at a distance of 20mm from the front edge of the cabinet, see diagram below.
Section A
CAVITY
15mm Battens
Mounting screws