Smeg MTK60X34 User manual

MTK60X34

PART IDENTIFICATION SHEET

60cm TRIM KIT –CABINET

PLACE THE TEMPLATE (no.8) ON THE LEFT SIDE OF THE
CABINET PAYING ATTENTION TO ITS POSITIONING AND
LOCK IT WITH ADHESIVE TAPE.
THE FRONT WALL OF THE TEMPLATE (A) MUST BE IN
LINE WITH THE FRONT OF THE CABINET
THE HOLE OF THE TEMPLATE (B) MUST BE
POSITIONED OUTWARDS
INSTALLATION PROCEDURE - 1
B
A

PLACE THE HOLDER-KIT (no.2)
IN ITS SEATAND FIX IT WITH 2
SCREWS (no.3)
(to facilitate the assembly of the
screw perform hole diameter 1 mm
with drill)
REPEAT THE OPERATION FOR
THE UPPER HOLDER-KIT AND
AFTER REMOVE THE TEMPLATE
INSTALLATION PROCEDURE - 2

REPEAT THE OPERATION ON THE RIGHT SIDE AND BLOCK THE
2 HOLDER-KIT ON THE CABINET (PLACE THE TEMPLATE, PLACE
THE HOLDER-KIT, FIX IT WITH 2 SCREW,REMOVE THE TEMPLATE)
INSTALLATION PROCEDURE - 3

A –DRAW THE HORIZONTAL CENTER OF THE CABINET
B –PLACE THE RIGHT BASE (no.5) ON THE CABINET BY MATCHING THE LITTLE
CUT WITHTHE HORIZONTAL CENTER OF THE CABINETAND SECURE IT WITH 3
SCREWS (no.6)
BA
IN THIS PHASE NOT INSERT THE SCREW IN THE HOLE
HIGHLIGHTED
INSTALLATION PROCEDURE - 4

PLACE THE LEFT BASE (no.4) ON THE
CABINET BY MATCHING THE CUTS
(RIGHT BASE AND LEFT BASE) AND
SECURE IT WITH 4 SCREWS (no.6)
IN THIS PHASE NOT INSERT THE SCREW
IN THE HOLE HIGHLIGHTED
INSTALLATION PROCEDURE - 5

REMOVE FROM OVEN ALL
INTERNALACCESSORIES
PLACE THE OVEN ON ITS SIDE
AND PERFORM THE PRE-
ASSEMBLY OF THE FRONT
BRACKET (no.7) IN THE
BOTTOM PART OF THE OVEN
WITH 2 SCREWS (no.6)
FOR A CORRECTASSEMBLY
MAINTAINING THE REFERENCE
HOLE (HIGHLIGHTED IN THE
PICTURE) ON THE RIGHT
INSTALLATION PROCEDURE - 6