Soho 41011 User manual
3 of 5
30-41011-V-01
STEP 1 " ASSEMBLY OF CRIB SIDES"
THIS STEP REQUIRES :
A.Head Board (1 pc)
C.Side Board (2 pcs)
D.Stabilizer Bar (1 pc)
N.Allen key (2 pcs)
F. Allenbolt 2 1/2"(65 mm) (4 pcs) G. Allenbolt 2 3/4"(70 mm) (4 pcs)
W. Spring washer (8 pcs)
L. Nut 3/4" (20mm) (4 pcs) M. Barrel Nut (4 pcs)
C
M
D
W
G
N
C
N
F
W
L
A
FACE
INSIDE RIGHT
INSIDE
STEP 1.1
STEP 1.2
STEP 1.1
- Insert Nut 3/4" [20mm] (L) through the top and bottom holes in headboard from the back side.
-Insert Allenbolt 2 1/2"[65mm](F), spring washer (W) through the top and bottom holes in Sideboard and
connect to the Headboard. Hand tighten only!
-Repeat STEP 1.1 for other Sideboard.
STEP 1.2
- Insert Barrel nut (M) into holes in Stabilizer Bar.
- Connect Stabilizer Bar to the Sideboard using (4 pcs) Allenbolt 2 3/4" [70 mm](G), Spring Washer (W) .
- Tighten all Bolts with Allenkey(N).
30-41011-V-01
STEP 2 " MATTRESS SUPPORT HEIGHT ADJUSTMENT "
THIS STEP REQUIRES:
This hardware is included in the CRIB.
K. Allenbolt 1"(25mm) (4 pcs) W. Spring washer (4 pcs)
L. Nut 3/4" (20mm) (4 pcs)
N. Allen key (2 pcs)
- Remove the Allenbolt 1"(25mm) (K) Spring Washer (W) and Nut 3/4"(20mm) (L) on
the Mattress Spring.
- Move Mattress Spring to the lowest position as shown in FIG.2.
- Attach the Allenbolt 1"(25mm) (K), Spring Washer (W) and Nut 3/4"(20 mm) (L) on the
lowest hole of Sideboard.
- Final position as shown in FIG.3.
FIG.3.
FIG.2.
N
K
WL
Lowest
position
