solarcentre LANCASTER User manual

LANCASTER
SOLAR TABLE LAMP USER GUIDE
Do NOT charge
behind glass
Do NOT place your
solar panel in shaded
areas.
E
W
S
Ensure your solar
panel is South facing
or as near as possible
Clean your solar
panel from time
to time
Thank you for choosing the Lancaster Solar Table Lamp. Please read these instructions carefully
before using your light.
Important notes
Always take care when installing your light. If you are at all unsure, please contact your retailer or a professional tradesperson for
advice.
Installation
Remove all packaging and put it to one side. Please carefully consider where you wish to install your light before making
alterations to your property. It’s particularly important that the solar panel receives as much sunlight as possible. Ensure that it is
not obstructed by buildings, fences, trees, sheds, etc, or the shadows that these create. If the solar panel is installed in a poor
location, it may not perform to the best of its ability.

time.
The lights will turn ON/OFF automatically when left in the on position. Please note it is completely normal for the lights to come

How to use

Please note for the solar panel to
charge, the lights must be kept in the ON position.
ON OFF
3sec 3sec
White R ing: Normal Working
Blue R ing: Standby Mode
R ED R ing: Charging Mode
Green R ing: F ull Charged Mode
4
3
2
1

solarcentre
making solar that works
For customer support please contact:
The Solar Centre Ltd
44-46 Coldharbour Lane
Harpenden T: 01727 743200
Hertfordshire W: solarcentre.co.uk
AL5 4UN E: inf[email protected].uk
Maintenance
Clean the surface of the solar panel and light lens with a soft, slightly moistened cloth. Do not use corrosive cleaning agents or chemical
solutions as these may damage surfaces and impair operation. Keep the solar panel free of dirt, debris and snow.
Safety Instructions
The Solar Centre assumes no liability for any damage resulting from the use of this product, nor do we assume liability for any damage
to property or personal injury caused by improper use or failure to observe these instructions.
Unauthorised conversion and/or modification of the unit may be dangerous and will invalidate your warranty. To avoid damage to sight,
do not look directly at the light source. This device is not a toy and should be kept out of reach of children. Do not submerge the device
in water or expose it to extreme temperatures (less than -25ºC or higher than 50ºC).
Troubleshooting
Please ensure that there are no nearby light sources shining on the solar panel after dark. These could be bright indoor/outdoor
lights from your property or neighbours or streetlights.
If you are unsure, take the light inside and test it in a dark room.
If you are encountering any problems with your lights often you can resolve this yourself by following our troubleshooting guide. If
the light has its solar panel in a poor location it will struggle to work, but that doesn’t mean there is a fault with the unit. Please
remember that the light will arrive with some charge and will likely work for a few days even if the solar panel is poorly located. Please
try the troubleshooting tips below before contacting your retailer.
Recharge Procedure
1. Double-check the location of your solar panel to ensure it is in a clear location and as South facing as possible.
2. Turn the light off at the switch and leave it to recharge for 3-5 days ensuring one sunny day has passed.
3. After 3-5 days return to the light and turn it back on at the switch.
4. If your light still does not illuminate after dark, please contact your retailer.
USB charging port
Modes
[Mode 1] Press and hold the light for 3 seconds to switch ON/OFF. Your light is now in the lowest brightness mode.
[Mode 2] Press for one second and your light is now on the medium brightness mode.
[Mode 3] Press for one second, your light is now on the brightest lighting mode.
[Mode 4] Press for one second, the light remains in standby mode.