soldio OGS-10W User manual
Rev.1
Off Grid／Grid Power Automatic Switcher
OGS-10W
2/ 15
OGS-10W
DC/AC
AC250V/10A
注意（設置・環境）
● 150mm
3/ 15
MAINSUB
MAINMAIN
/AC100240VINPUT = OUTPUT
INPUT = OUTPUT
4/ 15
1
MAIN
DC/AC MAIN
SUB
DC/AC SUB
10A DC/AC
MAINSUB
OUTPUT
10A
LED
MAIN LED SUB LED
5/ 15
Input
Output
MAIN
SUB
Output
LED
ON
ON
MAIN
ON
OFF
ON
SUB
OFF
ON
OFF
MAIN
ON
* DC/AC ON/OFF
2
● 2 () / 1 ()
● AC100~240V (50/60Hz)
● 10Amax (* 1)
●
AC100V1kW / 0.7kW (* 2)
AC220V2.2kW / 1.5kW (* 2)
AC240V2.4kW / 1.6kW (* 2)
● < 250 ms (* 3)
● 10 A (B)
● -20 ~ 60
●: (W)200 × (D)150 × (H)70 mm
● 1.1 kg
(* 1) 7A
(* 2) 0.7
(* 3)
6/ 15
3
unit: mm
M4
M5
7/ 15
1
(This warranty policy is valid in Japan only)
1
2
3
4
5
1
2
3
8/ 15
(Valid in Japan only)
修理ご依頼の際は、以下の点をご確認の上、本製品をご送付。
OGS-10W
No
-
TEL- -
E-Mail
-
-
--
http://www.fukushima-ele.co.jp/
sample
9/ 15
Instruction Manual Rev.1
Off Grid／Grid Power Automatic Switcher
OGS-10W
10 / 15
ATTENTION TO SAFETY
Introduction
Thank you for purchasing our OGS-10W.
Please read this operating manual before using this device.
After it is read, keep it to the place where the people handled can see it soon.
Symbols and meaning is classified as follows about safety of this manual.
WARNING
This symbol indicates that violating this item could cause serious personal
injuries or death.
CAUTION
This symbol indicates that violating this item could cause minor or medium
personal injuries, or loss of property.
In addition, it may lead to serious results depending on the situation also notes described.
Please observe always, because it describes the important content.
WARNING
Do not use the unit to the following extremely high reliability and applications that require safety.
Medical equipment and systems that directly related to human life.
Personal safety directly related applications.
(Ex: Ship, Car, Elevator operation and applications for control, etc.)
Important social and public system applications that might give serious damage.
(Ex: major computer systems, main communication equipment, etc.)
CAUTION
The unit is turned off momentarily output power at the time of the switching of the power supply
system. Do not use in personal computers and precision equipment and consumer electronics, such as is
required reliability and safety.
Please you turn off the DC / AC inverter and the load when making the connection to this unit.
Please put a circuit breaker protection on the input side of the commercial power supply.
Rating of the power cable, please use more than AC250V / 10A.
Do not disassemble or perform repairs yourself.
CAUTION (Mounting and Environment)
●Please have a good state of ventilation in case of mounting. Please this unit around spaced more than
150mm for cooling. This unit generates heat when the load current is large. Please away from other
products.
Do not place objects on top of this unit.
Do not use or store in the following locations. Otherwise an electric shock, fire, problem, or malfunction
could occur.
*Out-of-specification high temperature, low temperature, high humidity places and the confined areas.
*Side of the heat-generating devices, and direct sunlight.
*Rain or water drops fall. (Not waterproof)
*Corrosive gas, flammable gas, salt, iron, oil location, near flammable chemical products.
*Dusty place.
*Locations subject to vibration and shock.
Notes on abnormalities in use.
"Abnormal noise, smoke, fire etc", if you have found an anomaly from the product during use, please stop
using it immediately. Please ask the purchase shop or our company to the inspection and repair.
11 / 15
Feature
This unit is a device for automatically switching "Off-Grid (natural energy such as solar power) / Grid
Power (Commercial power or 2nd Off-Grid power)".
If the power of the "Off-grid power system (MAIN)" has stopped, it will be automatically switched to
"Grid power system (SUB)". When "Off-grid power system (MAIN)" is power return, switch to "MAIN".
INPUT / OUTPUT voltage is wide range (AC100 ~ 240V). (INPUT voltage value = OUTPUT voltage value)
Connection example
Note: INPUT voltage value = OUTPUT voltage value
12 / 15
1. Part names and functions
Front part
MAIN
Connect "the commercially available DC / AC inverter output". Please connect to the "MAIN" input port
from the Main power your system source.
SUB
Connect "the commercial power supply" or "Sub DC / AC inverter output". Please connect to the "SUB"
input port from the Sub power your system source.
CAUTION
The maximum permissible current of this unit is 10A. Please connect the DC /
AC inverter specifications that do not exceed this value. Over rated conditions
might cause deterioration, damage, smoke and fire.
Emergency, unplug both the "MAIN" and "SUB".
OUTPUT
Connect the load. The output voltage is the same as the input port voltage. Please be careful in the
rating of the connected load.
CAUTION
The maximum output permissible current of this unit is 10A. Please use the
current consumption of the load is below this value. Over rated conditions might
cause deterioration, damage, smoke and fire.
In addition, Please do not connect inductive load such as a large motor.
This unit might be damaged due to causes such as inrush current.
Top part
LED indicator of switch direction
When "MAIN" system is output, LED lights up green. When "SUB" system is output, LED is turned off.
13 / 15
Switching Table
Input
Output
MAIN
SUB
Output
LED
ON
ON
MAIN
ON
OFF
ON
SUB
OFF
ON
OFF
MAIN
ON
* Sunrise and sunset time, when the load current is large, ON / OFF motion of the DC / AC inverter (Off-grid power
system) might occur frequently. In that case, the switching motion of this unit also occurs at the same time.
2. Rated and Specification
●Input / Output ports: 2-ports (In) / 1-port (Out)
●Input / Output voltage: AC100~240V (50/60Hz)
●Maximum output current: 10Amax (* 1)
●Maximum output power:
AC100V1kW / 0.7kW (* 2)
AC220V2.2kW / 1.5kW (* 2)
AC240V2.4kW / 1.6kW (* 2)
●Switching time: < 250 ms (* 3)
●Internal fuse: 10 A (Glass tube, Class B)
●Operating temperature: -20 ~ 60 °C
●Dimensions: (W) 200 × (D) 150 × (H) 70 mm (Include protrusion)
●Weight: 1.1 kg
(* 1) If you want to connect the inductive products such as fan and motors etc, please use at "< 7A" total current value.
(* 2) "Resistive load" / "Inductive load (power factor 0.7)"
(* 3) Please don't use the computer, the precision equipment, because there is a moment of power off.
14 / 15
3. Appearance, mounting dimension
unit: mm
Please attach at M4 or M5 screw.
15 / 15
211-0014
68-5 Tajiri-cho, Nakahara Ward, Kawasaki City,
Kanagawa, Japan
TEL: +81-44-522-4511
http://www.fukushima-ele.co.jp/
Warranty(Outside Japan)
1. Warranty information
●The warranty period is one (1) year from the date of purchase. If there is failures or malfunction during
the warranty period under normal use, it will be repaired free of charge.
●Free repair during the warranty period will be accepted from the purchase shop or an authorized our
distributor only.
If the purchase shop is not in our distributor list, or international web shop will be "limited warranty".
"Limited Warranty" covers free of charge spare parts, but the labor for the repair is chargeable.
●For all warranty claims the proof of purchase / invoice is required. Please also attach a note wrote a
detailed failure symptoms and your system condition.
●Direct repair request and inquiries from overseas users is not accepted in principle. Even if we accepted
during the warranty period the repair is chargeable.
Note: Transportation or shipping costs including any customs duties are not covered by the warranty.
2. Warranty exclusions
In the following cases, not covered under warranty.
●Malfunction or damage due to misuse, modification or improper repair.
●Malfunction or damage due to improper handling (e.g. dropping) after purchase or caused during
transportation or moving.
●The serial number on the unit has been altered, or removed.
●Malfunction or damage due to a fire, earthquake, flood, lightning, other natural disaster, deterioration
of environment, salt damage, abnormal voltage, use of non-specified power supply (voltage or frequency)
or other extrinsic factors.
●There is damage caused by improper installation or improper connection to an external peripheral
device, and other such devices.
●There is damage from use outside the operation or storage parameters or environment detailed in
manual.
●Replacement of consumable parts such.
For more inquiries and details warranty matters, please visit our distributor or our official website.
http: //www.fukushima-ele.co.jp/
Development / Manufacture
FUKUSHIMA ELECTRIC Co., Ltd.
Table of contents
