Solid 07202 User manual

Assembly instructions Solid wood garden bench and garden chair, Art. 07202, 07212, 07232 and 07102
PLEASE NOTE and keep it for later use!
Congratulations on purchasing your new solid wood garden furniture. With the purchase of this furniture, you have opted for a first-class
processed quality product.
Please note the following informations during use and assembly so that you enjoy your new garden furniture for as long as possible.
Maintenance
In case of prolonged rain, it is recommended to store or cover the furniture. In case of shorter showers, tilt the furniture so that no water
can collect on the seating and table surfaces. In winter, the furniture should be stored dry. When covering with a furniture cover, ensure
adequate ventilation.
The furniture is factory treated porous with an environmentally friendly water-based wood stain. They should be repainted at regular
intervals with a suitable wood preservative glaze for outdoor use (shade pine or darker, according to taste). How often such a treatment
is necessary depends mainly on the weather conditions. If the bank is very exposed to the weather, repainting the bank before use may
make sense.
Assembly
Parts List:
• Seat part, back part, foot parts left and right, center strut
• 4x screw M8x120mm with washer and nut
• 12x Spax screw 5,0x60mm.
Step 1
Place the bench seat upside down on a flat surface.
Insert the back piece and hook in with the help of 1x M8x120mm screw.
Do not screw together yet!

Step 2
The two foot parts are made in mirror image (right and left). Based
Select the right foot part for each side of the holes, as on
to see the picture. Then the foot parts per side with 2x screw
Hand-mount M8x120mm, washer and nut.
Step 3 and 4
Pull the backrest backwards until it rests flush against the foot parts. Then tighten the nuts of the four lock screws. Install 4x Spax Screw
5.0x60mm per side at the pre-drilled locations as shown in figures 3 and 4.
Always make sure that the backrest does not shift. This must always be flush with the foot part.
The seat itself is not completely on the foot part, this is not necessary due to the design.
Step 5
Insert and align the center brace between the feet.
Screw with two Spax screws per side as shown.