SolidDigi SD-505 User manual
SD-505 Battery Car charger (Optional)
Summary
SolidDigi sd-500 Working based on existing GPRS netwo rk and GPS satellites, this product can
locate and monitor any remote targets by GPRS Compatible OPENGTS.
Hardware Description
Front face Rear face
1/5
SolidDigi SD-505 GPRS GPS TRACKER USER MANUALSD-505 GPRS GPS TRACKER USER MANUAL
Downloaded from Arrow.com.
Usage：
SIM card installation isplay is on, and PIN code off. The
SMS message must in Text format, can’t be identified for PDU format.
Steps :
1 Open the rear cover, and pick out the battery.
2 Push the foil along and turn it left.
3 Put the SIM card into the holder, and turn the foil right and fasten it in place.
Battery and Charger
Do charge the battery to capacity in 8 -12 hours for first use. Please use the battery and charger provided
by the manufacturer. This unit adopts built-in Li-ion battery, and full battery will support around 48 hours
use on end.After first use, the battery can be charged fully in 3-5hours.
Cautions:
a: For it is Li-ion battery, which contains harmful chemicals and may burst, please do not bump, puncture it
violently and keep it off fire.
b: Please charge the battery in time to keep it working normally.
Startup
Put the SIM card and battery in place.
The unit turns on automatically when the sim card and battery is inserted.
For first use, please initialize the unit and restore it to default setting.
In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well
as the GPS signals. The indicator will keep flashing every 4 seconds when the unit
has received the signals, otherwise it will keep on.
When this unit receives GPS signals normally, you can use it and do all the following
Settings.
Initialization default settings
Send “begin+password” in SMS to the tracker, it will reply“begin ok”and initialize all the settings. (default
password: 123456)
Change the Password
Send SMS password+old password+space+new password to change the password.
Remark:
Be sure keep the new password in mind, you have to upload the firmware to restore the original setting in
case of losing the new password.
Make sure the new password is in 6 digits, or else the tracker can not recognize the password
3/5
Make sure that there is no call transfer and call d
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
SMS Center
Send SMS “adminsms+123456+space+cell phone number”to set the SMS center.
If the SMS center is set up, when an authorized number sends SMS or makes a calll to the tracker, the
tracker will reply a SMS with Geo-info & authorized number to SMS center.
Cancel: Send SMS noadminsms+password to cancel theSMS center.
Response SMS format: authorized number+Geo-info
◆The SMS message must in Text format, can’t be identified for PDU format.
◆Power on the tracker outdoor when use the tracker for the first time, it can search the GPS signal nearby,
it also greatly shorten the time of searching the GPS signal for the future use.
GPRS Setting
In order to use GPRS function, the user needs to set IP, Port and APN ( access point
name ) by either cell phone, or our PC software.
（NOTE: Some countries or regions should set APN’s User Name and APN’s
Password.）
Set an IP address and port:
Setup: Send SMS adminip+123456+space+IP address+space+port.
If setup successful, the tracker will reply SMS “adminip ok”
Cancel: Send SMS noadminip+123456
Set APN
Setup: Send SMS apn+123456+space+specify apn content.
If setup successful, the tracker will reply SMS “APN ok”.
Cancel: The oldAPN will be invalid automatically when a newAPN is set.
Set APN’s User Name
Setup: Send SMS apnuser+123456+space+the sim card’s user name.
If setup successful, the tracker will reply SMS “apnuser ok”.
Cancel: The old APN user name will be invalid automatically when a newAPN uer
name is set.
Set APN’s Password
Setup: Send SMS apnpasswd+123456+space+the sim card’s password.
If setup successful, the tracker will reply SMS “apnpassword ok”.
Cancel: The oldAPN password will be invalid automatically when a newAPN password
Auto-Track
Report a Geo-info at 60s intervals to the authorized numbers for 5 times:
Setup: Send SMS t060s005n+password to the unit, it will report the Geo-info at
60s intervals for 5 times.(s: second, m: minute, h: hour). The setting must be in 3 digits
and at maximum 255 in value.
Send SMS t060s***n+password to the unit, it will Kept send Geo-info to opengts.
Cancel: Send notn+password to stop the “ auto track ”
Remark: the interval must not be more than 5s
SD card function
A mini SD card can be put in the tracker’s SD card slot. The GPRS data can be saved in
the SD card if GPRS is off. It will send data to the GPRS server again if GPRS is on.
Setup: Send SMS sdlog123456 1 to the tracker to activate the function of storing
data in SD card;
Cancel: Send SMS sdlog+password+0 to the tracker to deactivate the function of
storing data in SD card.
Setup: Send SMS readsd+password+space+1 to ask the tracker to send data in
4/5
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
the SD card to the GPRS server.
Cancel: Send SMS readsd+password+space+0 to ask the tracker to stop sending data
in the SD card to the server.
GPRS transport mode
Send SMS gprsmode+123456+space+0 (default setting,for china opengts )
gprsmode+123456+space+1 (for other countries opengts)
If setup successful, the tracker will reply SMS “GPRSMODE ok!”
IMEI Checking:
Send SMS imei+password to the unit to check the IMEI number of the tracker.you will
SOS Button
The SOS button only work in SMS mode.
Press the SOS for 3 second, it will send “help me !+ Geo-info”to all the authorized numbers every 3
minutes. It will stop sending such a SMS when one of the authorized number reply SMS ”help me!”to the
tracker.
CAUTIONS
Please comply with the instructions to extend the unit life:
1. Keep the unit dry. Any liquid, i.e. rain, moisture, may destroy or damage the inside circuitry.
2. Don’t use & store the unit in dusty places.
3. Don’t put the unit in overheated or overcooled places.
4. Handle carefully. Don’t vibrate or shake it violently.
5. Clear the unit with a piece of dry cloth. Don’t clean in chemicals, detergent.
6. Don’t paint the unit, this may cause some foreign materials left in between the parts.
7. Don’t disassemble or refit the unit.
8. Please use the battery and charger provided by manufacturer. Using other batteries and chargers will
cause unwanted situation.
9. Don’t dismount the antenna randomly, or use other antennas. This may interfere the transmission, and
increase the radiation as well.
5/5
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
Table of contents
