SOLIDMATION HPA-2130 User manual

Automation made simple. lwww.solidmation.com
Electrical Installation:
Electrical installation shall be done by an authorized
electrical technician or a qualified professional.
Specifications
HPA-2130 supports two motors load, or one motor
and one light xture with transformer and dichroic
lamps, with connection to a Switch on/off
The core functions enabled for each channel are
as follows:
lPush-button On/Off
lToggle On/Off
HPA-2140 is prepared to be connected to toggle
or push-button switches, with the dimmable switch
function being its standard conguration.
In case of having toggles available, the toggle
function must be congured from the software.
The core functions enabled for each channel are
as follows:
In-wall modules
HPA-2130: Dual appliance switch
Two-channel non-dimmable switch for general
purposes: motors, lamps, etc.
HPA-2140: Dual dimmer
Two-channel dimmable switch for resistive loads,
halogen lamps, incandescent bulbs, etc.
Installation manual
lDimmable push-button
lDimmable toggle
lToggle On/Off, with dimmered power-on and
power-off
lToggle On/Off
In-wall module devices from Home Automation
series are designed to be exclusively installed in
standard electrical boxes tted behind light switch
panel.
Electrical connection diagram “A” shows an
example of an installation with 2 incandescent
bulbs.
In case of failure or defects, please contact
authorized technical support.
Technical characteristics
lVoltage: 100-240 VAC 50/60 Hz.
lQuantity of independent channels: 2
lMaximum section of cables for installation: 1.5 mm2
lMaximum output voltage:
lHPA-2140: 2.5A (sum of both channels)
Example: Channel 1: 2A and Channel 2: 0.5A
HPA-2130: 1.5A (sum of both channels)
Neutral
Supply Line
Solidmation-MA-HPA-2130_2140_V3-Installation_Manual-00-EN
Connection diagram “A”
Toggle 1
Toggle 2

l• www.solidmation.com | inf[email protected]om lwww.solidmation.com | inf[email protected]om
lwww.solidmation.com | inf[email protected]om
1. Turn power off.
2. Dismantle the box containing the toggle / push-
button to control light xtures.
Procedure for proper installation
3. Conrm there is a neutral wire and a supply line
wire to supply power to toggle/push-buttons,
otherwise you will have to install the missing wire.
4. In already existing installations, disconnect the
wires from the toggle/push-button.
Wiring:
5. HPA-2140 and 2130: Connect Red, Blue and Black
wires, coming from the In-wall module switch to the
toggles or push-buttons.
6. Connect neutral and line wire to the input terminal
of the In-wall module switch.
7. HPA-2140 and 2130: Connect the wire
corresponding to the load to be controlled, which
will be triggered by toggle No.1, at output No. 1.
Proceed the same way with the connection for the
second lamp for the output No. 2.
8. Check that connections are done according to
Diagram “A”.
9. Carefully place the switch at the bottom of the box,
on a vertical position if possible.
10. Mount the switch frame and cover.
Congratulations, your equipment is now ready to be
congured using Habeetat Planner software.
Solidmation S.A. | All rights reserved. Subject to changes without prior notice.