1
Sonos Mount
• The easy-to-install mount for Sonos One and Play:1
• Holds speaker normally, upside-down, or even horizontally
• Speaker can pivot up to 45 degrees
• Allows access to ports, buttons, and touch controls
• Cleanly routes your speaker’s cables
Important: This mount is intended for use only with Sonos One and Play:1.
What’s in the box?
•Mount
• Wall bracket
• Top cap
• Mounting kit
Note: Sonos speakers sold separately.
What you’ll need
• Pencil
•Level
• Phillips-head screwdriver
• Power drill (if needed for installation location)
WALL MATERIAL PRE-DRILL USE WALL ANCHORS USE SCREWS
Wood stud 1/8” / 3mm bit No Yes
Drywall (no stud) 5/16” / 8mm bit Yes Yes
Hard wallboard or
double board
5/16” / 8mm bit Yes Yes
Plaster 5/16” / 8mm bit Yes Yes
Concrete or Brick 5/16” / 8mm bit Yes Yes
Sinclair Mount.fm Page 1 Thursday, February 20, 2020 3:57 PM
