Optional Input/Output Boards for HDCU-3300
HDC-3300 HD Super Motion Colour Camera
General
Power requirements AC 240 V, 1.4 A max.
DC 12 V, 8.6 A max.
Operating temperature -20 °C to +45 °C (-4 °F to +113 °F)
Storage temperature -20 °C to +60 °C (-4 °F to +140 °F)
Mass Approx. 4.8 kg (10 lb 9 oz) (without VF and lens)
Dimensions (W x H x D) 154 x 197 x 348 mm (6 1⁄8x 7 7⁄8x 13 3⁄4inches)
Camera section
Pickup device 3-chip 2/3-inch type CCD
Effective picture elements 1920 (H) x 1080 (V)
Signal format 1920 x 1080 images: 1080/180i (59.94i), 1080/150i (50i)
1280 x 720 images: 720/180p (59.94p), 720/150p (50p)
Sensitivity F7 at 2000 lx (3200K, 89.9% reflectance)*
Signal-to-noise ratio 54 dB (typical)*
Horizontal resolution 1000 TV lines (at centre)*
Spectral system F1.4 prism
Built-in filters ND: 1: CLEAR, 2: 1/4ND, 3: 1/8ND, 4:1/16ND,
5: 1/64ND
CC: A: CROSS, B: 3200K, C: 4300K, D: 6300K,
D: 8000K
Signal inputs
Mic input XLR-3-pin, female (x1)
Audio input CH1: XLR-3-pin, female (x1), MIC or LINE or
FRONT MIC selectable
CH2: XLR-3-pin, female (x1), AES/EBU or MIC or
LINE selectable
Signal outputs
HD-SDI/SD-SDI output** BNC (x1), HD-SDI or SD-SDI, character on/off selectable
Test output BNC (x1), VBS (SD) or VF: Y/R/G/B (HD) or HD-sync or
SD-sync selectable
Other inputs/outputs
CCU Optical/electrical multi-connector (x1)
Intercom XLR-5-pin, female (x2)
Prompter output BNC type (x2)
DC input XLR-4-pin (x1), DC 10.5 to 17 V
DC output 4-pin (x1), DC 10.5 to 17 V (max. 1.5 A)
Lens 12 pin (x1)
Viewfinder 20 pin (x1)
Earphone Stereo mini-jack (x1)
Return control 6 pin (x1)
Remote 8 pin (x1)
Tracker 10 pin (x1)
Crane 12 pin (x1)
Supplied accessories
Operation manual (x1), Cable clamper (x1),
Cable clamp band (x1), +B3x10 screws (x3),
Switch label (x2)
* 1080/180i mode
** When the HDC-3300 camera is not connected to the HDCU-3300 camera control
unit, the HD-SDI output signal is for maintenance purpose only.
HDCU-3300 HD Super Motion Camera Control Unit
General
Power supply AC 100/120/220 to 240 V, 50/60 Hz
Current consumption 5.6 A max.
Operating temperature +5 °C to +40 °C (+41 °F to +104 °F)
Storage temperature -20 °C to +60 °C (-4 °F to +140 °F)
Mass Approx. 16.8 kg (37 lb)
Dimensions (W x H x D) 424 x 133 x 410 mm (16 3⁄4x 5 1⁄4x 16 1⁄4inches)
excluding projection
Signal inputs
HD-SDI return input BNC (x4), SMPTE 292M, 1.485/1.4835 Gb/s
SD-SDI return input BNC (x4), SMPTE 259M, 270 Mb/s
VBS return input BNC (x4)
Reference input BNC (x2, 1 for loop-through output)
HD: SMPTE 274M, tri-level sync, 0.6 Vp-p, 75 ΩΩ
SD : Black burst, NTSC : 0.286 Vp-p, 75 Ω,
PAL : 0.3 Vp-p, 75 Ω
Prompter input BNC (x4, 2 for loop-through output),
analogue NTSC/PAL/HD-Y, 1.0 Vp-p, 75 Ω
AC input (x1), AC 100, 110 to 120, 220 to 240 V switchable
Signal outputs
HD-SDI LINK A/B/C BNC (x6), SMPTE 292M, 0.8 Vp-p, 75 Ω,
Super Motion output 1.485/1.4835 Gb/s
Link A (x2), Link B (x2), Link C (x2)
HD-SDI output BNC (x4), SMPTE 292M, 1.485/1.4835 Gb/s
SDI output BNC (x4), HD-SDI/SD-SDI selectable
(SDI output 3, 4: character on/off selectable)
HD: SMPTE 292M, 0.8 Vp-p, 75 Ω, 1.485/1.4835 Gb/s
SD: SMPTE 259M, 0.8 Vp-p, 75 Ω, 270 Mb/s
Sync output BNC (x1), HD sync/SD sync selectable
HD: BTA-S001A, tri-level sync, 0.6 Vp-p, 75 Ω
SD: composite sync, 0.3 Vp-p, 75 Ω
Character output BNC (x1), VBS, 1.0 Vp-p, 75 Ω
AES/EBU output BNC type (x1), AES/EBU format, 20-bit/ 48 kHz
Mic output XLR-3-pin, male (x2), 0/-20 dBs selectable
WF mode 4-pin (x1)
Other inputs/outputs
CAMERA Optical/electrical multi-connector (x1)
10.692/10.681 Gb/s Serial digital x2,
240 V AC power supply
Intercom/Tally/PGM D-sub 25-pin (x1)
Intercom (PD/ENG) : 4W/RTS/CC, 0 dB
Tally : R, G tally, 24 V power in/make contact
PGM: 0/-20 dB selectable
RCP/CNU 8-pin (x1), Sony Camera System-700 Control Protocol
(for entire camera system control)
Ethernet RJ-45 (x1), 10BASE-T/100BASE-TX
Trunk A 12-pin (x1)
Trunk line D-sub 9-pin, female (x1), RS-232C
Mic remote D-sub 15-pin (x1)
Supplied accessories
Operation manual (x1), Number plates (1 set), Fuses (1 set)
HKCU-1001 SD Analogue Interface Unit
VDA-A board
VBS output BNC (x2), 1.0 Vp-p, 75 Ω
PIX output BNC (x1): VBS/R/G/B selectable, VBS: 1.0 Vp-p, 75 Ω
WF output BNC (x1): VBS/R/G/B selectable, VBS: 1.0 Vp-p, 75 Ω
HKCU-1003 Multi Interface Unit
VDA-A board
VBS output BNC (x2), 1.0 Vp-p, 75 Ω
PIX output BNC (x1): VBS/R/G/B selectable, VBS: 1.0 Vp-p, 75 Ω
WF output BNC (x1): VBS/R/G/B selectable, VBS: 1.0 Vp-p, 75 Ω
Specifications
VDA-B board
Frame reference input BNC (x1)
Frame reference output BNC (x1)
PIX output BNC (x1): VBS/R/G/B selectable, VBS: 1.0 Vp-p, 75 Ω
WF output BNC (x1): VBS/R/G/B selectable, VBS: 1.0 Vp-p, 75 Ω
HKCU-1005 HD/SD Expansion Unit
HD-SDI/SD-SDI output BNC (x4), HD-SDI/SD-SDI selectable
(SDI output 3, 4: character on/off selectable)
HD: SMPTE 292M, 0.8 Vp-p, 75 Ω, 1.485/1.4835 Gb/s,
SD: SMPTE 259M, 0.8 Vp-p, 75 Ω, 270 Mb/s
Services from
Sony
Recognising that every company and every challenge is unique, we offer a complete and comprehensive range of
services all the way through consulting, planning, financing, implementation, training, servicing, maintenance and support.
Choose exactly what’s right for you, when and where you need it.
■ Sony Professional Services: Tailor-made design, installation and project management of audio-visual and IT (AV/IT) systems
using skills developed over 25 years of systems integration.
■ Sony Financial Services: Innovative and flexible finance solutions designed to meet budgetary and financial requirements and
constraints, enabling businesses to always have the most current technology.
■ Sony Training Services: A range of off-the-shelf or customised training services from basic operation through to high-level
technical maintenance.
■ Sony Prime Support Services: Fully integrated and customised support for products and systems throughout their operational
life, combining proactive and reactive technical services.
Not all services are available in all countries. If you’d like to find out more about what we do, who we do it for and how we
do it, visit www.sonybiz.net or contact your local Sony office.