
Sony Electronics Inc.
•
16530 Via Esprillo
•
San Diego, CA 92127
•
1.800.222.7669
•
www.sony.com
Please visit the Dealer Source for current information at
www.sony.com/dealersource
220 Watts x 2 RMS at 4 Ohms
440 Watts x 2 max power at 4 Ohms
270 Watts x 2 RMS at 2 Ohms
650 Watts x 2 max power at 2 Ohms
540 Watts x 1 RMS at 4 Ohms
1400 Watts x 1 max power at 4 Ohms This unit can be used
as a bridging amplifier with a maximum output of 1400 Watts
at 4 Ohms.
High Level input with Sensing Power On Direct connection
(High Level Input) can be made with the speaker output of
your car audio unit if it is not equipped with RCA line output. Hi
-
Level Sensing power On feature allows the unit to be activated
without need for remote connection.
50
-
300 Hz Variable Low
-
pass filter, 12 dB/oct Built in variable
12 dB/Oct LPF (Low Pass Filter) from 50
-
300Hz enables users to
concentrate the power on lower frequencies.
6
-
70 Hz Variable subsonic filter, 12 dB/oct Built in variable 12
dB/Oct Subsonic filter from 6
-
70Hz enables users to create a
band pass filter and block extremely low frequencies to
improve the subwoofer systems efficiency.
0
-
10 dB Variable 40Hz Low boost Variable 0
-
10 dB 40Hz bass
boost provides additional bass response at lower frequencies.
Specifications
Audio
FrequencyResponse: 10
-
50 kHz (+0/
-
3 dB)
InputLevel: 0.3
-
6.0V (RCA input) or 1.2
-
12.0V (High Level Input)
Impedance: 2
-
8 Ohms Stereo or 4
-
8 Ohms Mono
Operation: 2/1 channel configuration
ToneControl(s): Low Pass Filter: 50
-
300Hz, 12dB/Oct
Subsonic filter: 6
-
70Hz, 12dB/Oct
HarmonicDistortion: 0.05% (at 1kHz)
LowBoost: 0
-
10dB Variable (at 40Hz)
Signal
-
to
-
Noise Ratio (dB): 93 dBA
Power
OutputPower: Maximum Output: 440 Watts x2 or 1400 Watts x1
(at 4 Ohms)
CurrentDrain: At rated output: 50A (at 4 Ohms)
Remote Input: 1 mA
RatedOutput: (20Hz
-
20kHz, 1% THD+N, 14.4V) 220 Watts x 2
RMS (4 Ohms)
270 Watts x 2 RMS (2 Ohms)
540 Watts x 1 RMS Mono (4 Ohms)
PowerRequirements: 12V DC Car Battery (Negative Ground)
Internal Power Supply: OTL Output Transformerless Circuit
Pulse Power Supply
InputVoltage: 10.5
-
16V Power Supply Voltage
Inputs and Outputs
RCA Audio Input(s): Pin Jacks: 0.3
-
6V
AudioIn: RCA Pin Jacks, High Level Input Connector
AudioOut: Speaker terminals with screws
Dimensions
Weight: 7 lbs. 15 oz.
Measurements: 16 3/4 x 2 1/4 x 11 1/8" (424 x 55 x 280 mm)
Supplied Accessories
Mounting Screws (4)
High Level Input Cord (1)
Protection cap (1)
Color:
Gray and Silver
UPC Code:
027242773066
1.CEA
-
2006Compliant —
Standardized
“
Voluntary
”
Testing&MeasurementMethodsforMobileAudio
Amplifiers. This standard advocates a uniform method for determining an amplifier
’
s RMS power and signal
-
to
-
noiseratio. Using 14.4 volts, RMS watts are measuredinto a 4
-
ohmimpedanceloadat1percentTotal
HarmonicDistortion (THD) plus noise, at a frequencyrange (for general purpose amplifiers) of 20Hz to
20,000Hz.
©2010SonyElectronicsInc.Allrightsreserved.Reproductionin whole or in part without writtenpermissionis
prohibited.Sony, Quick
-
BrowZer,Walkman, Xpl
ō
d, ZAPPIN, and the Sony and Xpl
ō
dlogosaretrademarksof
Sony.iPodisatrademarkofAppleInc.All other trademarks are trademarks of theirrespectiveowners.
Features and specifications are subject to change without notice. Non
-
metricweightsandmeasuresare
approximateand may vary.