Sony CFD-676L User manual

SONY.
CD Radio
Operating Instructions page 2™
Bedienungsanleitung Seite 2°
CFD-676L
CFD-C626S
©1995 by Sony Corporation
Cassette-Corder

Den
Warning
To prevent fire or shock hazard, do
not expose the player to rain or
moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.
Information
For customers in Europe and Saudi Arabia
CLASS 1 LASER PRODUCT
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
This Compact Disc player is classified as a
CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT label is
located on the rear exterior.
About This Manual
The instructions in this manual are for the
CFD-616L and CFD-C626S. Before you start
reading, check your model number. The
CFD-C626S is the model used for illustration
purposes.
introduction
Notice for customers in the United
Kingdom
A moulded plug complying with BS 1363 is
fitted to this equipment for your safety and
convenience.
Should the fuse in the plug supplied need to
be replaced, a 5 AMP fuse approved by ASTA
or BSI to BS 1362, (i.e. marked with @ or Y
mark) must be used.
If the plug supplied with this equipment has
a detachable fuse cover, be sure to attach the
fuse cover after you change the fuse. Never
use the phug without the fuse cover. If you
should lose the fuse cover, please contact
your nearest Sony service station.
IMPORTANT
If the plug supplied is not suitable for the
socket oultets in your home, it should be cut
off and an appropriate plug fitted in
accordance with the following instructions.
The wires in this mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead
of this apparatus may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Do not connect either wire to the earth
terminals in the plug which is marked by the
letter E or by the safety earth symbol + or
coloured green or green-and-yellow.
WARNING
To prevent shock hazard, do not insert the
plug cut off from the mains lead into a socket
outlet. This plug cannot be used and should
be destroyed.

Table of contents
10
Basic Operations
Playing a CD
Listening to the radio
Playing a tape
Recording on a tape
12
13
14
15
17
19
20
21
22
The CD Player
Playing multiple discs
Using the display
Locating a specific track
Playing tracks repeatedly
(Repeat Play)
Creating your own program
(Program Play)
The Radio
Presetting radio stations
Playing preset radio stations
The Tape Player
Recording through a
microphone/Using as a PA
system
The Timer
Falling asleep to music
seepeerepe a
23
26
27
29
31
32
34
Setting Up
Hooking up the system
Selecting the audio emphasis
(Sound Mode/MEGA BASS)
Additional Information
Precautions
Troubleshooting
Maintenance
Specifications
Index
introduction
i
RENE
suoiesado 2182 |
EN

Basic Operations
Playing a CD
For hookup instructions, see pages 23 - 25.
1 Press & OPEN/CLOSE (direct
OPEN/ power-on) and place the disc on
CLOSE the disc tray.
Note
You can't play 3 inch (8 cm) CDs even
with an adaptor for single-CDs.
With the label side up
2 Press Pl. Display
cD The disc tray closes and the
player plays all the tracks once.
: Track number
Music calendar Playing time
4 | Basic Operations

Tips
* If “ALL DISCS” lights
up, the player plays
other CDs in numerical
sequence. To play only
one CD, press DISC
MODE to select “1
DISC.”
* Next time you want to
listen to a CD, just press
Pll. The player turns on
automatically and starts
playing the CD.
Use these buttons for additional operations
POWER Pil Bo i4<4/>1 AMS/SEARCH
wo
9
2,
Qn
ie)
a]
os
VOLUME +/- ey)
st
°
i]
wv
& OPEN/CLOSE
To Press
Adjust the volume VOLUME +/-
Stop playback a
Pause playback Pil
Press again to resume play
after pause.
Go to the next track bt AMS/SEARCH
Go back to the previous track K@ AMS/SEARCH
Remove the CD & OPEN/CLOSE
Turn on/off the player POWER
Basic Operations | 5°

es
=
Pe
8
For hookup instructions, see pages 23 - 25.
Press BAND until the band you
want appears in the display
(direct power-on).
CFD-C626S only: To tune in an
SW band, first press BAND to
display “SW,” then press PLAY
MODE MONO/ST/mBAND to
display the sub-band you want.
Display
YOR
watt
ee ee
wt ate =
— TUNING +
Ca Ge)
Hold down TUNING+ /— until
the frequency digits begin to
change in the display.
The player automatically scans
the radio frequencies and stops
when it finds a clear station.
If you can't tune in a station,
press the button once at a time.
6™ | Basic Operations -
Indicates an FM
stereo broadcast.

Tips
If the FM broadcast is
noisy, press PLAY
MODE/MONO/ST/
mBAND until “Mono”
appears in the display
and the radio will play
in monaural.
Next time you want to
listen to the radio, just
press the BAND button.
The player turns on
automatically and starts
playing the previous
station.
CFD-C626S only: If you
need to change the MW
tuning interval (preset
to 9 kHz at the factory),
see page 24.
Use these buttons for additional operations
POWER VOLUME +/-
ow
o
2
ia
Oo
B°)
a
=
9
_
o
oo
nn
To Press
Adjust the volume VOLUME +/-
Turn on/off the radio POWER
To improve broadcast reception
Reorient the antenna for FM. Reorient the player itself
for MW (CFD-C626S) or MW/LW (CFD-616L). For
SW (CFD-C626S only), pull the antenna vertically.
a ears
a tbe
na}
For MW/LW
Basic Operations | 7°

Stata A eae fea yh eh aia leader ea as BN tog ase ER A Prenat d COB pe etna oni sata
For hookup instructions, see pages 23 - 25.
1 STOPIEJEGT Press Hi to open the tape
compartment and insert a
recorded tape. Close the
compartment.
With the side you want
to play facing up.
2 pay Press >.
The player turns on (direct
power-on) and starts playing.
E
8 | Basic Operations

Tips
¢ Next time you want to
listen to a tape, just
press B» . The player
turns on automatically
and starts playing the
tape.
© For the best results, use
TYPE I (normal) tape.
Use these buttons for additional operations
POWER BA iH
To Press
Adjust the volume VOLUME +/-
Stop playback BA
Fast-forward
or
rewind
the
tape
>
or
<4
*
Pause playback i
Press the button again to
resume play after pause.
Eject the cassette gs
Turn on/off the player POWER
* After winding the tape with PP or 4, press HS to
release it.
Basic Operations
suonjeiado rseg zg
9 EN

Por hookup instructions, see pages 23 - 25.
Press Hi to open the tape
compartment and insert a blank
tape.
STOP/EJECT
With the side you want to
record on facing up
2 Select the program source you
want to record. Display
To record from the CD player,
Cc) insert a CD (see page 4) and press
on the CD section.
To record from the radio, press om vo.
RADIO BAND and tune in the station wal
FM aged
you want (see page 6.) a Bh
3 Bee pay Press @ to start recording. (B> is
depressed automatically.)
Basic Operations
4 of