Sony SU-PT2M User manual

© 2004 Sony Corporation
SU-PT2M 4-099-468-12 (1)
4-099-468-12 (1)
Tabletop Stand
Instructions
SU-PT2M
GB
CS
CT
KR
AR

SU-PT2M 4-099-468-12 (1)
2(GB)
Thank you for purchasing this product.
To Customers
Sufficient expertise is required for installing this product. Be sure to subcontract the installation to Sony dealers
or contractors and pay special attention to safety during the installation. Sony is not liable for any damages or
injury caused by mishandling or improper installation.
WARNING
If the safety precautions are not observed or the product is used incorrectly, it may result in serious injury or fire.
This instruction manual shows the correct handling of the product and important precautions necessary to prevent
accidents. Be sure to read this manual thoroughly and use the product correctly. Keep this manual available for
future reference.
For Sony dealers
Sufficient expertise is required for installing this product. Be sure to read this instruction manual thoroughly to do
the installation work safely. Sony is not liable for any damages or injury caused by mishandling or improper
installation. Please give this manual to the customer after installation.
On Safety
Products by Sony are designed with safety in mind.
If the products are used incorrectly, however, it may result in a serious injury through fire, electric shock, the
product toppling over, or the product dropping. Be sure to observe the precautions for safety to prevent such
accidents.
CAUTION
This Tabletop Stand is intended for use only with the following products. Use with other apparatus is capable of
resulting in instability causing possible injury.
Specified product (As of June 2004)
Plasma TV KE-MX37A1 KE-MX37S1 KE-MX37N1 KE-MX37K1
KE-MX42A1 KE-MX42S1 KE-MX42N1 KE-MX42K1 KE-MX42M1

SU-PT2M 4-099-468-12 (1)
English
GB
3(GB)
For Customers
WARNING
If the following precautions are not observed, serious injury or death through fire, electric shock, the
product toppling over, or the product dropping can result.
Be sure to subcontract the installation to Sony dealers.
If persons other than Sony dealers do the installation work, this may result in serious injury, as the TV is very
heavy.
Be sure to take measures to prevent the stand from toppling over.
If you fail to do so, the Tabletop Stand may topple over and cause injury or property damage.
Anchor the TV to the wall, pillar, etc. to prevent it from toppling over.
Be sure to install the Tabletop Stand on a solid and flat surface.
Do not install the Tabletop Stand so that it leans in one direction. If you do so, the
Tabletop Stand may topple over or the TV may fall. This may cause injury or
property damage.
Be sure to install the Tabletop Stand on a stable surface.
If you install the Tabletop Stand on an unstable surface, it may lose its balance and
topple over or fall off. This may cause injury or property damage.
Do not lean on or hang from the TV with the TV installed on the Tabletop
Stand.
The Tabletop Stand may topple over, or the TV may fall and cause serious injury or
death.
Do not cover the ventilation hole of the TV.
If you cover the ventilation hole (with a cloth, etc.), heat may build up inside and
cause fire.

SU-PT2M 4-099-468-12 (1)
4(GB)
Do not allow the mains lead or the connecting cable to be pinched.
•Do not allow the mains lead or the connecting cable to be pinched when you
install the TV on the Tabletop Stand. If the mains lead or the connecting cable is
damaged, this may result in a fire or an electric shock.
•Do not step on the mains lead or the connecting cable when you carry the
Tabletop Stand. The mains lead or the connecting cable may be damaged, and
this may result in a fire or an electric shock.
Be sure to carry the stand in the manner shown in this manual.
If the Tabletop Stand is carried incorrectly, it may topple over and cause injury.
Do not stumble over the mains lead or the connecting cable.
If you stumble over the mains lead or the connecting cable, the Tabletop Stand may topple over and cause injury.
CAUTION
If the following precautions are not observed, injury or property damage may occur.
Do not install any equipment other than the specified product.
This stand is designed for use with the specified product only. If you install equipment other than specified, it may
fall and cause injury or property damage.
Be sure to secure the TV.
Secure the TV to the Tabletop Stand using the supplied screws.
If the TV is not installed securely, it may fall and cause injury.
Notes on installation
Install the stand on a solid and flat surface. Do not allow the stand to be installed at an angle or incline. To avoid
this, observe the following precautions.
– If you install the stand on a soft surface such as a mat or a carpet, lay a board over the designated location
beforehand.
– Do not install the stand in a place subject to direct sunlight or near a heater.
–Do not install the stand in a hot or humid place, or outdoors.
Note on use
To keep the stand clean, occasionally wipe the stand with a dry soft cloth. Stubborn stains may be removed with a
cloth slightly dampened with diluted detergent. Then wipe the area with a dry soft cloth. Do not use chemicals,
such as thinner or benzine, as they damage the finish of the stand.

SU-PT2M 4-099-468-12 (1)
5(GB)
WARNING
To Sony Dealers
The following instructions are for Sony Dealers only. Be sure to read safety precautions described above
thoroughly and pay special attention to safety during the installation, maintenance, checking and repair of this
product.
Be sure that two or more persons do the installation work.
Be sure that two or more persons install the TV on the Tabletop Stand. If one person does the installation work
alone, this may result in an accident or an injury.
Be sure to install the TV securely, following the instructions in this manual.
Be sure to tighten the screws firmly.
If the TV is not installed securely, it may fall and cause injury.
Be careful not to hurt your hands or fingers during installation.
Be careful not to hurt your hands or fingers when installing the TV.
Check the parts
Name Quantity Name Quantity
Bottom plate Cable tie
1
Securing screw
14
Anchor attachment
2
Prepare a Phillips screwdriver, that fits the screws indicated above, beforehand.

SU-PT2M 4-099-468-12 (1)
6(GB)
Install the TV
WARNING
If you allow the mains lead to be pinched under or between pieces of equipment, this may result in a short
circuit or an electric shock. If you stumble over the mains lead or the connecting cable, the stand may topple
over and cause injury.
Decide on the installation location and lay the stand down before installing the TV.
Since the TV is heavy, it is recommended that you decide on the installation location beforehand and lay the
Tabletop Stand down there before installing the TV.
Note
Do not push or pull the Tabletop Stand while it is on the floor. The rubber footings on the base of the stand may
come off.
1Attach the Tabletop Stand to the TV.
1Place the TV, with its screen facing down, on a stable, cloth-covered work surface, at least 20 cm off the
floor.
2Insert the dowels of the Tabletop Stand in the slots of the TV.
2Secure the TV and the Tabletop Stand with the supplied screws.
Note
When using an electric screwdriver, set the torque setting to about 1.5N·m.
1
2
At least
20 cm
Rear side of the TV
Soft rag
Bottom of the TV
Slots
Securing screw

SU-PT2M 4-099-468-12 (1)
7(GB)
3Connect the mains lead and the connecting cable to the TV.
Tip
See the instruction manual of Plasma TV (KE-MX37A1, KE-MX37S1, KE-MX37N1, KE-MX37K1, KE-
MX42A1, KE-MX42S1, KE-MX42N1, KE-MX42K1, KE-MX42M1) for more details on connecting the mains
lead and the connecting cable.
4Bundle the mains lead and the connecting cable with the supplied cable
tie.
Mains lead and connecting cables

SU-PT2M 4-099-468-12 (1)
8(GB)
Safety measures to prevent toppling over
WARNING
Be sure to take measures to prevent the stand from toppling over.
If you fail to do so, the TV may topple over and cause injury. Anchor the TV to a wall, pillar, etc., to prevent it
from toppling over.
Prepare a commercially available rope or chain and wall anchor bracket beforehand.
1Remove the screws attached to the TV, and replace them with the supplied anchor attachments.
2Secure the wall anchor bracket to a solid wall or pillar.
3Pass the rope or chain through both holes of the anchor attachments and then tighten the other end of the
rope or chain to the wall anchor bracket.
132
Wall anchor
bracket

SU-PT2M 4-099-468-12 (1)
9(GB)
Specifications
Design and specifications are subject to change without notice.
Dimensions: (mm) A 584
B 286
C 410
D 125
E 181
Weight: (kg) 6
A
C
DE
B

SU-PT2M 4-099-468-12 (1)
10 (GB)