southpaw enterprises 2255 User manual

southpaw enterprises, inc.®
Instruction Sheet
Floor Mirror 2255
Store these instructions in a safe place or
with the enclosed maintenance checklist
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST
1 -Folding Side Support
1 -Mirror / Blackboard with fixed side bolts
2 -Black Plastic Knobs
4 -Large Washers
1 -Instruction Sheet
1 -Maintenance Checklist
IMPORTANT: Keep all parts together.
ASSEMBLY PROCEDURES
1. Remove the knobs and one washer from each side of the
mirror.
2. Unfold the frame (Fig. 1) and gently spread the tops of each
side support until you can place the mirror between them.
(Fig. 2).
3. Put one of the bolts into the hole on the top of one side
support, then put the bolt on the opposite side into the hole
on the other side support. Put one washer and aknob on
each bolt.
4. Tighten knobs firmly. DO NOT OVER TIGHTEN!
5. To remove the protective covering from the mirror, lift at
edges. If there is any difficulty removing the sheeting, use
aliphatic naphtha, kerosene, or distilled alcohol to moisten the
adhesive. Do not use other chemicals or sharp objects to
remove the sheeting.
TO ADJUST THE ANGLE OF THE MIRROR
1. Loosen knobs (Fig. 3).
2. Move mirror to desired angle.
3. Tighten knobs firmly.
SPECIAL NOTES
•The floor mirror is not designed to be used parallel to the
floor in a table-like manner.
•Do not use tape on mirror surface.
Fig. 1
Fig. 3
Side Support
Mirror/Blackboard
Black
Knob
Fig. 2
Mirror/Blackboard
Black
Knob
Washers
Bolt
Side Support

MAINTENANCE CHECKLIST
All of the following wear points should be checked on a monthly basis and recorded on the checklist enclosed.
•Check all wooden parts for chips or splinters. Sand smooth and refinish with polyurethane or discontinue use.
•Check for scratches on mirror. Small scratches can be removed by hand polishing with a plastic scratch remover
or compound cleaner. Remove all residue and polish with a flannel cloth.
•Check hardware to make sure it is securely attached. If hardware is not securely attached, tighten screws. If it is
still not secure call Southpaw for repair or replacement.
STORAGE PROCEDURES
•Store out of direct sunlight. Sunlight will yellow the mirror surface.
•Store where not accessible by clients without proper supervision.
CLEANING INSTRUCTIONS
Check with your infectious disease department before using these procedures.
•Check for client allergies first.
•Wood parts can be dusted as needed. If necessary, wood can be cleaned with a damp cloth using soap and water
or disinfectant. Dry before using.
•Mirror cleaning instructions: Do not use window sprays or kitchen scouring compounds. Water cannot be
used freely on the mirror. The mirror should be first dusted very lightly (not wiped) with a soft clean cloth. Then
use a mild dish soap, water and a soft cloth to wipe the surface. Apply only light pressure. Grease and oil may be
removed with kerosene or aliphatic naphtha (no aromatic content). Do not use solvents such as acetone,
benzene, carbon tetrachloride, dry cleaning fluid, or lacquer thinner as they attack the mirror surface.
•A surface gloss can be maintained by occasionally using a flannel cloth and a good plastic cleaner or polish such
as Johnson’s Pledge. Follow the instructions on container.
•The blackboard surface may be cleaned using a damp cloth.
Safety Precautions -The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no
condition should this equipment be used without proper supervision.
This sheet is for example only. It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware -it is
your responsibility to find all pertinent safety information that pertains to your facility.
♦MATTING PRECAUTIONS: Always use appropriate matting.
♦SAFETY NOTES: Mirror should not be placed in high traffic area. Do not allow client’s to sit or climb on
Floor Mirror.
♦WARNING: Plexiglass has been known to break upon impact. If cracked, discontinue use immediately and
contact Southpaw for repair or replacement.
CAUTION