Sovereign SGT 30 User manual

Quick Start Guide
Your Safety is most important
please read these safety rules before you use this machine
General Safety Rules
Read user manual before using the machine
Wear safety goggles to guard your eyes from possible injury
Wear gloves to protect your hands
Wear safety shoes to protect your feet
ᏟWear hearing protection
Note - This quick start guide is intended for experi-
enced users who have already assembled the tool,
please refer to the manual for further details

Quick Start Guide
1Unpack the Grass Trimmer
a) Open carton carefully and remove all items
b) Ensure you have all items (see above) before you discard the packaging
3
4
For your Safety
You must fit the guard provided for your safety. Undo the bolt with Allen key provided (see Fig 1). Place the guard over the lower shaft (see
Fig 2), replace the bolt and tighten (see Fig 3)
Also fit the centre handle. Undo the locking Knob and remove the bolt (see Fig 4) push, the handle over the upper shaft (see Fig 5), replace
the bolt and secure with locking knob (see Fig 6). Fit the carry strap to the unit with the clip to the hook on the upper shaft (see Fig 7)
2Assembling the Grass Trimmer
Connect bottom shaft (6) to Upper shaft & engine (7) making sure the square drive shaft on lower shaft (6) is inserted into square drive on
upper shaft (7) correctly and ensure the spring loaded locking clip is aligned with hole provided and in place and the securing knob is tighte-
ned. If the drive is not correctly inserted then the spool will not turn.
Items Included
Do you have questions?
We can help
Call Customer Service
Mon-Thur 08:45 am - 5:00 pm
Friday 08:45 am - 3:15 pm
岼
0151 649 1500
Spare Parts also available
Fuel / Lubrication
a) Mix the fuel in the mixer bottle provided
b) Shake the container gently to ensure that it is properly mixed.
N.B Failure to use the correct oil/fuel mixture will cause the
engine to seize
5Starting the Grass Trimmer
a) Add the fuel to the grass trimmer
b) Switch Ignition to “I” (on)
c) Set Choke lever to On
d) Secure throttle lever on
e) Push primer bubble 10 times
f) Pull starter cord rapidly 4 or 5 times
NOTE: amount of choke will vary slightly
depending on the external temperature
g) Allow engine to warm up at half throttle for
a short time and then push the choke in fully
Fuel Mixture is
40:1 (40 parts Fuel to 1
part 2 stroke oil)
Use regular grade unleaded
petrol and quality 2 stroke oil
EH 11/2007
1
3
4
5
Fig 1 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 Fig 7
2
6
10 98
7
1 Spanner
2 Mixing Bottle
3 Plug Socket & Lock Bar
4 Allen Key wrench
5 Bottle of 2 stroke oil
6 Lower Shaft
7 Engine & Upper Shaft
8 Guard
9 Handle
10 Carry Strap
Throttle lever
Upper Shaft (7)
Bottom Shaft (6)
Spring Loaded
Locking Clip
Securing knob
Hole for locking clip
Securing knob
Spring Loaded
Locking Clip
Fuel Cap / tank
Starter cord
Primer bubble
behind plastic
guard
Choke lever
Throttle lever lock
Ignition Switch