Speakman SA-1209 User manual

INSTRUCTIONS FOR MODELS
92-SA-1209-R2
For additional assistance or service please contact:
SPEAKMAN®Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
customerser[email protected]
www.speakman.com
SA-1209
TOOLS AND SUPPLIES
SAFETY TIPS
Be sure to wear eye protection.
MAINTENANCE
Your new Speakman Product is designed for years
of trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool, and harsh chemicals
as these will dull the finish and void your warranty.
WARRANTY
Additional warranty information can be found at:
www.speakman.com
Level
1/4 “Tile Drill Bit
(if mounting to tile)
Rubber
Hammer
Drill with 1/4” bit
or 1/2 “bit
Phillips
Screwdriver
Flat Tip
Screwdriver
Measuring
Tape
Pencil
HELPFUL TOOLS & SUPPLIES:
REQUIRED TOOLS & SUPPLIES:
1
Place Mounting Plates into desired position，
using a level to position them accordingly.
Mark mounting hole locations with a
pencil. Remove Mounting Plate from wall.
11 13
16
"
300mm
2
Option A -- Tile Wall
Option A -- Tile Wall
Drill 1/4 in. holes in the previously
marked locations.
Ø1/4 in.
2
Option B --
Option B --
Drywall with Steel Backer Plate.
Drywall with Steel Backer Plate.
Drill 1/2 in. holes in the previously marked
locations.
OR
Ø1/2 in.
3
Option A -- Tile Wall
Option A -- Tile Wall
Insert Plastic Anchors into hole and use
rubber hammer to position Plastic Anchor
flush with wall surface.
3
Option B --
Option B --
Drywall with Steel Backer Plate.
Drywall with Steel Backer Plate.
Loosely assembly toggles through Mounting
Plate.
OR
4
Option A --
Option A --
Tile Wall
Tile Wall
Insert screws through Mounting Plate and
secure Mounting Plate to wall by tightening
screws.
OR

4
Option B --
Option B --
Drywall with Steel Backer Plate
Drywall with Steel Backer Plate
Place toggle bolts through mounting holes
in wall surface.Secure Mounting Plate to wall
by tightening bolts
OR
5
Place Bracket over Mounting Plate
6
Secure Bracket by tightening set screw
at bottom.
7
Insert glass shelf into C clips.
8
Secure Glass Shelf to Brackets using Set
Screws. Tighten with Flat Tip Screw-
driver. Take care to not over tighten or
damage may occur.
9
Installation Complete.
SA-1209 ROUGH-IN DIAGRAM
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
11 13
16
"
300mm
23
16
"
55mm
17 11
16
"
450mm
51
4
"
134mm