SportsPlay 562-605 User manual

562-605 LaCrosse Goal - Portable
Page 1
Rev 08/10/2004
IMPORTANT
PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING ASSEMBLY. All equipment
must be installed in accordance with these instructions. Check your shipment
against Bill of Lading and Parts list. Any missing or broken parts must be
reported to your distributor within 10 days of receipt of your order. When
properly installed and maintained, equipment will give many years of Safe,
Trouble-Free use. Periodically check for loose or broken parts. Loose bolts
must be tightened and broken parts must be replaced as they can possibly
create dangerous situations leading to unnecessary accidents.
PACKING LIST HARDWARE BAG
1 CTN 1 Hardware Bag 2 126-701 3/8” x 1 ¼” Button Head Bolt
1 CTN 1 565-932 Net pair 8 196-807 3/8” x 3/8” Socket Set Screw
PIPE 2 563-507 Cross Bar 2 226-602 3/8” Nylon Insert Lock Nut
PIPE 4 563-505 Upright 4 316-601 3/8” Flat Washer
PIPE 4 536-508 Base Half 1 416-350 3/16” Socket Key
1 416-505 7/32” Long Arm Socket Key
10 905-517 3/8” x 12” Spike
50 905-518 11” Wire Tie
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
www.sportsplayinc.com
2 CTN 10 PIPE 12 TOTAL PCS # Weight Class 70

562-605 LaCrosse Goal - Portable
Page 2
Rev 08/10/2004
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
www.sportsplayinc.com
GENERAL ASSEMBLY INSTRUCTIONS:
1. Check each piece carefully and remove any sharp projections that may
have been caused by shipping.
2. DO NOT Tighten bolts more than hand tight until entire assembly is
completed.
3. All Threaded ends of bolts protruding beyond nuts should be cut off and
peened over to remove any sharp edge.
SPECIFIC ASSEMBLY INSTRUCTIONS:
1. Assemble goal on ground.
2. Connect frame halves using 3/8” x 1 ¼” Button Head Bolts, 3/8” flat
washers, and 3/8” Lock Nut. Assemble with nut at BOTTOM of portable
frame. Tighten using the 7/32” Socket Key.
3. Attach uprights to portable frame halves using 3/8” socket set screws.
Only hand-tighten until goal is completely assembled.
4. Attach crossbar to uprights using 3/8” socket set screws. Only hand-
tighten until goal has been completely assembled.
5. After all posts have been connected and are plumb and level, making
sure to maintain the 6’ x 6’ inner opening of the goal, tighten set
screws and bolts using socket keys.
6. Position goal and stake down in four places.
7. Attach net to frame using wire ties.
MAINTENANCE INSTRUCTIONS:
Check periodically for loose bolts and/or broken parts and replace
immediately.