Spring USA SR-181A User manual

Built-In Induction Range
Model # SR-181A
Technical Data
Accessories & Options
Note: Specifications are subject to change without notice, please refer to website for the latest specifications
One-year warranty on parts and labor.
127 Ambassador Drive, Suite 147 Naperville, IL 60540-4079 • Phone [phone] • Fax [phone]
www.springusa.com
Part No: SR-181A Operating voltage: 110-120v Heating Power 1800W Hz: 60 Amperage: 15.0 Dimensions: 12-5/8” x 13-3/8” x 4-3/8”
Weight: 8.5 lbs. Power cord: 6’, 3 prong Approvals: FCC, ETL, ETL to NSF4, CETL NEMA Plug:5-20
Wood Induction Cabinet Model
Part No: SRC-181 Operating voltage: 110-120v Heating Power 1800W Hz: 60 Amperage: 15.0 Dimensions: 14-1/8” x 20-1/8” x 6”
Weight: 16 lbs Power cord: 6’, 3 prong Approvals: FCC, ETL, ETL to NSF4, CETL NEMA Plug:5-20
Double Induction Wood Cabinet Model
Part No: SRC-2-181 Operating voltage: 110-120v Heating Power 1800W Hz: 60 Amperage: 15.0 Dimensions: 29-1/2” x 20-1/8” x 6”
Weight: 37 lbs Power cord: 6’, 3 prong Approvals: FCC, ETL, ETL to NSF4, CETL NEMA Plug:5-20 Each Range
Model # SRC-181

INSTALLATION:
1. Cut hole to specifications illustrated.
2. Install the control box unit before the cooktop hole on the
counter.Apply silicon to all sides of the cooktop hole on the
counter surface.
3. Gently place the cooktop into the hole and adjust its position
such that all sides are evenly flat.
4. Use the provided screws to mount the control box to the
counterside.
5. The control box has a 1.5 ft. cord; extension cords of 4.5 feet
may be purchased separately. The control box must not be
located further than 6 feet from the unit.
Attention:
1. If the ceramic glass top plate edge or surface is cracked or
broken- do not install the cooktop.
2. Silicone must be used to seal the cooktop onto the counter to
prevent spilt liquids from leaking through.
3. Counter thickness cannot exceed 1 inch.
4. Space at the rear of the cooktop must be at least 7 3/4 inches.
Note: In the event that the rear clearance of 7 3/4" cannot be
accommodated, the unit can be turned. Clearance of 7 3/4" must
be available at the side to which the rear of the unit is turned.
5. Space at both sides of cooktop must be at least 4 inches.
6. Space beneath cooktop must be at least 7 inches.
7. SR-181A- This product’s electrical specifications are
......120v/60hz/1800w and each unit must independently use a
15 amp outlet. Absolutely do not use other appliances
on the same 15 amp circuit.
INDUCTION COOKTOP INSTALLATION