Spy Earpice 3W Amplified Phone Neckloop User manual

3W Amplified Phone Neckloop
Overview
Quick Start
Connect to mobile phone
Plug the jack into mobile phone audio port.
The mobile phone will alarm connected to stetro
headset.
Then you can turn on power switch and start to use
the neckloop.
Default plug is 3.5mm 4pins. You can choose 2.5mm 4pins or Nokia flat jack. Different mobile phones require different jacks.
1) 3.5mm 4pins jack fit to PC/laptop/ipod/ipad/mp3/mp4 players and most of the smart phones with iOS, Android, Bada systems.
Also works with some Nokia mobile phones.
2) 2.5mm 4pins jack fit to most of Nokia mobile phones.
3) Nokia flat jack is for Nokia phone only.
** Even the jack is the same, the audio and microphone connections might be different.
If the jack does not work on your mobile phone, please contact seller to get guidance of how to change jointing methods
on the circuit board.
** You can also advice the model number of mobile phone before place the order, we will do necessary modification to
make sure the jack could works with your mobile phone.
To be continued..
2011 new design. Build in 3watt audio amplifier.
Supports all kinds of wireless earpieces and provides
very loud sounds. 2 colors are available, skin and black.
Package includes:
1 x phone neckloop (black or skin color)
1 x USB recharge cable
1 x USB AC charger
Power Adaptor Recharge Cable
ON
OF F
Answer
Button
Volume
Control
Power Switch
Inductive
Neckloop
Phone Jack
Indicator
PAGE 1
1
Audio Sources
Mobile phone, mp3, ipad, etc
ON
OFF
Neckloop
Plug
into audio port
www.Spy-Earpiece.com

3W Amplified Phone Neckloop
Wear the neckloop
You can wear the neckloop on neck, like right side sketch showing.
Can also put neckloop in coat pocket or put on legs when you are
site down to drive sensitive earpieces including TE07/TE08P/TE09.
Turn on power and change volume
After connected to mobile phone and wear on neck, you need to turn on power by turn the switch to up position.
The blue working indicator in right side nearby the power switch will turn on.
Try to play music in mobile phone, now you can hear sounds in invisible earpiece (check how to use earpiece in manual of earpiece).
If volume is too loud, the earpiece will make noise. In this condition, you should turn volume controler down to lower
the volume. Then earpiece will creates clear sounds without noise.
To drive the TE 01 magnetic earpiece, you need to max the volume to get strongest power to drive it.
If long time no use, please turn off the switch and save power.
Start a covert conversation
Make a phone call to telephone or another mobile phone, you can talk
with your partner from the microphone build-in neckloop.
If your partner calls you, you can tape answer button to active the call.
** If there is an earpiece detector, you can turn off the power switch to
cut off audio output and avoid been detected.
Battery and recharge
The neckloop is build-in 230mah lithium rechargeable battery. The full performance a new battery is achieved only after two
or three complete charge and discharge cycles. The battery can be charge and discharge hundred of times, but its eventually
wear out.
Recharge battery use only original default USB recharge cable and default wall charger. Do not leave a full charged device on
recharge power source. Because overcharging may shorten battery life. If left unused, a full charged battery will loss its charge
over time.
We supply US/EU/UK standard plugs for the wall charger. Please choose correct plug while place the order.
To be continued...
PAGE 2
3
2
Wear Neckloop
Volume
Controler
Turn on
Power Switch
ON
OFF
4
ON
OFF
Tape
answer phone call
Microphone
5
www.Spy-Earpiece.com

3W Amplified Phone Neckloop
Troubleshotting
Q. Why can not work with my mobile phone?
A. Please compare with the jack of original mobile phone headset and check if jack of neckloop is fit your mobile phone or not.
If confirm both are the same, you can contact sellers to require supports of change jointing methods on circuit board.
Q. Why answer button no works?
A. Its also the jack problem. Because different mobile phone use different jointing method for each pins. You can contact
seller to get guidance of how to make modifications on jointing method.
Q. How to recharge battery?
A. Please read “Quick Start” step #5 to get detail instruction. After connected to power charger successfully, the red color
of rechargeing indicator will turn on. Recharge indicator is in same position of working indicator in right side.
Q. Why I heard noise in invisible earpiece?
A. If earpiece has no quality problem, the reason is volume is too loud. You should turn volume controler down to reduce volume
and then will get clear sounds in invisible earpiece.
Q. How to avoid earpiece detector with this neckloop?
A. You can turn off the power switch to avoid earpiece detector. Phone conversation will still be online after turn off power.
Warranty and return policy
Default warranty is 12 months since ship date.
We do not accept return if product has not quality problem.
If product is within warranty and get broken, you can return back and get free repair. Return shipping cost is on buyer’s behalf.
We will pay the shipping cost for send repaired product.
If product is passed warranty, you need to pay return shipping cost, repair fee and shipping cost for send repaired product.
Warranty will be invalid in below conditions:
1) Passed 12 months since ship date.
2) Open case or and change circuits without our formal authorization.
3) Other kinds of problems caused by wrong operations.
Thank you for reading and Happy eCommerce!
PAGE 3www.Spy-Earpiece.com