SSV Works US-C65 User manual

US-C65
Universal Cage Mount
6.5” Speaker Enclosures
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in
material or workmanship. All SSV Works Electronics are covered by a limited 1 year
warranty against defects in material or workmanship. Labor for replacement of defective
components is not covered. All SSV Works Speakers are covered by a limited 1 year
warranty against defects in material or workmanship. Contact SSV Works for further
warranty information.
TOOLS NEEDED FOR INSTALLATION
PARTS LIST IMAGES
1. US-C65 Enclosures (1 pair)
4. M6 Hex Head Bolts &
Washers x4
5. M6 Allen Socket Head Bolts
& Washers x4
3. Ring Clamp x 4
6. M6 Set Screws x 4 7. #7 Screws x 8
(for use with unloaded pods only)
2. Dual Mounting Ring
Adapter x 2
- 5mm Allen Key - 8mm Open End Wrench
INSTALLATION NOTES
It is recommended to wrap the bag that the clamps come in around the cage before you slide the clamp onto the cage to prevent scratching.

D. Place both ring mounting clamps on the cage using the plastic bag to prevent scratching, place the cage mount pod in its nal mounting location and
secure to the clamps using the two (2) M6 allen socket head bolts and washers with a 5mm allen key.
US-C65
A. Find the best orientation for the speaker on your bar and
screw in the Set Screws in the OPPOSITE holes of where the
clamp will install into.
B. Loosely install the clamp base to the cage mount pod with the
two (2) M6 hex head bolts and washers, place the cage mount
pod in the desired mounting location on the vehicle. Once the
ring adapter is in the desired position, tighten the two (2) bolts
using a 8mm open wrench.
A B
Connect and install the speaker into the enclosure (be sure to connect the “+” speaker wire to the “+” terminal on the speaker and the
“-“ speaker wire to the “-“ terminal on the if not using a SSV Works speaker). Use a #2 Phillips screwdriver to mount the speaker to the
pod using the provided #7 (holes are pre-drilled for use for #7 screws)
D D D
WHEN INSTALLING YOUR OWN SPEAKER:

F. Route the speaker wire away from any moving parts and any
sharp metal, then connect to the amplier
US-C65
F
WIRING INSTRUCTIONS
For proper sound when not using the SSV Works speaker harness, ensure the speaker polarity is correct connect the “+” to the “+” and the “-“to the “-“from
the speaker wire to the amplier. If using with an SSV Works complete system refer to the amplier wiring instructions for more detailed wiring information.
“+” “+”
“ - ”“
- ”
© 2017 SSV Works, Oxnard, CA 93030 US-C65 Rev. C 10-25-17
Amplier
Connecting the US-C65 using the pre-installed, two-pin connector will require an optional SSV Works plug-&-play harness (WP-H1150 - sold
separately). If you are not using the WP-H1150 harness, simply cut off the two-pin connector and follow the wiring instruction below.
USING A SSV WORKS HARNESS