SSV Works US2-C65 User manual

!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or
workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects
in material or workmanship. Labor for replacement of defective components is not covered. All
SSV Works Speakers are covered by a limited 1 year warranty against defects in material or
workmanship. Contact SSV Works for further warranty information.
INSTALLATION NOTES
It is recommended to wrap the
bag that the clamps come in
around the cage before you
slide the clamp onto the cage to
prevent scratching.
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
TOOLS NEEDED FOR INSTALLATION
PARTS LIST IMAGES
1. US2-C65 Enclosures (1 pair)
5. M6 Hex Head Bolts &
Washers x4
6. M6 Allen Socket Head Bolts
& Washers x4
3. Ring Clamp x 4 4. Aftermarket Speaker Adapter
(comes with unloaded pods only)
7. M6 Set Screws x 8 8. #7 Screws x 8
(comes with unloaded pods only)
2. Dual Mounting Ring
Adapter x 2
- 5mm Allen Key
- 3mm Allen Key
- 8mm Open End Wrench
- #2 Phillips Screwdriver
Placement of the pod depends on what type of roll
cage you have (factory or aftermarket) and your
preference of where you want the pods to be installed.
In these instructions, we have installed them on the
outside vertical bars at the back of the roll cage.
US2-C65
Universal Cage Mount
SSV Works 6.5” Speaker Enclosures
FOR UNLOADED ENCLOSURES:
If using a different brand speaker, rst see if
the speaker holes line up with the screw bosses
(circled in pink on Figure 1). Be sure to use the
8 supplied SSV Works #7 screws when installing
your own speaker.
Figure 1

D. Position the speaker to your liking and tighen the hex head
bolts by hand with a 8mm wrench.
E. Route the speaker wire away from any moving parts and any
sharp metal, then connect to the amplier.
D E
A. Find the best orientation for the speaker on your bar and
screw in the Set Screws in the OPPOSITE holes of where the
clamp will install into.
B. Loosely install the clamp base to the cage mount pod with the
two (2) M6 hex head bolts and washers, place the cage mount
pod in the desired mounting location on the vehicle.
A B
C. Place both ring mounting clamps on the cage using the plastic bag to prevent scratching, place the cage mount pod in its nal mounting location and
secure to the clamps using the two (2) M6 allen socket head bolts and washers with a 5mm allen key.
C C C
© 2018 SSV Works, Oxnard, CA 93030 US2-C65 Rev. A 3-30-18
Connecting the US2-C65 using the pre-installed, two-pin connector will require an optional SSV Works plug-&-play harness (WP-H1149 - sold separately). If
you are not using the WP-H1149 harness, simply cut off the two-pin connector and follow the wiring instruction below.
WIRING INSTRUCTIONS
For proper sound, ensure the speaker polarity is correct connect
the “+” to the “+” and the “-“to the “-“from the speaker wire to the
amplier. If using with an SSV Works complete system refer to the
amplier wiring instructions for more detailed wiring information.
“+”
“+”
“
- ”
“
- ”