SSV Works WC2-FKP65 User manual

WC2-FKP65
Textron Wildcat
6.5” Speaker Front Kick Panels
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against
defects in material or workmanship. All SSV Works Electronics are covered by a
limited 1 year warranty against defects in material or workmanship. All SSV Works
Speakers are covered by a limited 1 year warranty against defects in material or
workmanship. Labor for replacement of defective components is not covered.
Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
PARTS LIST IMAGES
2. M6 x 16mm
Screws x 12
1. WC2-FKP65
Enclosures (1 pair)
3. M6 Washers x 12
- T-30 Torx Driver - Drill with 1/4” Drill bit- Phillips Screwdriver - Scribe or Punch tool
A. Bolt down the pod brackets like above
using ve (5) M6 Screws and Washers.
B. Set the unloaded pod in place and mark the top mounting
location with a scribe or punch tool on to the oorboard.
C. With a 1/4” drill bit, drill the screw hole for mounting the
speaker pod.
A
B C
4. #7 Screws x 8

F. Ensure this mounting tab is inserted between the metal frame
and the plastic panel.
G. Using the factory hardware, bolt down the bottom and side
bracket. Using the supplied nut, bolt down the top mounting
screw.
Route the speaker wire away from any moving parts and any sharp metal, then connect to the amplier.
Connecting the WC2-FKP65 using the pre-installed, two-pin connector will require an optional SSV Works plug-&-play harness (WP-H1149 - sold separately).
If you are not using the WP-H1149 harness, simply cut off the two-pin connector and follow the wiring instruction below.
Repeat for the other side
F G
E. Connect the speaker harness to the enclosure harness and use a screwdriver
secure the speaker to the pod (E1) Place the loaded enclosure in location
for mounting (E2).
E2E1
WC2-FKP65 © 2017 SSV Works, Oxnard, CA 93030 WC2-FKP65 Rev. A 12-22-17
WIRING INSTRUCTIONS
For proper sound, ensure the speaker polarity is correct
connect the “+” to the “+” and the “-“to the “-“from
the speaker wire to the amplier. If using with an SSV
Works complete system refer to the amplier wiring
instructions for more detailed wiring information.
“+”
“+”
“ - ”
“ - ”
D. Remove the indicated factory screws from the wheel well.
Save the screws as these will be used to mount the kick panel.
D